Reviewing The Most Recently Recorded Scene (Last Scene Review) - Sony NXCAM HXR-NX80 Operating Manual
Solid-state memory camcorder
Hide thumbs
Also See for NXCAM HXR-NX80:
- Simple live streaming quick manual (5 pages) ,
- Service manual (156 pages)
Table of Contents
Advertisement
Useful functions (Continued)
When [60i] is selected
FRAME
START
RATE
TRIGGER
960
Approx.
3 sec.
480
Approx.
4 sec.
240
Approx.
5 sec.
When [50i] is selected
FRAME
START
RATE
TRIGGER
1000
Approx.
3 sec.
500
Approx.
4 sec.
250
Approx.
5 sec.
b Notes
• The supported memory cards that can be used
vary depending on the file format (p. 27).
• In Super Slow Motion recording, the camcorder
may continue recording after you press the
START/STOP button to stop recording (up to 3
minutes). Do not operate your camcorder while
the [REC] indicator is flashing on the screen,
and wait till it turns to [STBY].
• After you stop recording, your camcorder
continues recording till it completes writing 0.5
seconds unit of data.
• The shutter value may not be displayed
correctly when recording in Super Slow Motion
if [SHUTTER DISPLAY] is set to [DEGREE]
(p. 120).
• Available only when the AUTO/MANUAL
switch is set to MANUAL. Note that iris, ISO
sensitivity/gain, and shutter speed are fixed to
manual.
• When the [FRAME RATE] is set to [960]
([1000]), the image displayed and recorded
shifts approximately 1.35 times toward the
telephoto side.
62
REC TIMING
END
END
TRIGGER
TRIGGER
HALF
Approx.
Approx.
3 sec.
1 sec.
Approx.
Approx.
4 sec.
2 sec.
Approx.
Approx.
5 sec.
2 sec.
REC TIMING
END
END
TRIGGER
TRIGGER
HALF
Approx.
Approx.
3 sec.
1 sec.
Approx.
Approx.
4 sec.
2 sec.
Approx.
Approx.
5 sec.
2 sec.
• When the [FRAME RATE] is set to [480] or
[960] ([500] or [1000]), the picture will be
slightly degraded relative to normal shooting.
• Changing the ISO sensitivity/gain, shutter
speed, or white balance will cause degradation
of the image on the LCD screen, but the camera
settings in force when shooting ends are applied
to the recorded image. For details about
displaying camera data, see page 67.
• To change the frame rate setting, first stop
recording.
• The timecode is recorded in [REC RUN] mode
(p. 123).
• Super Slow Motion mode is automatically
canceled when the camcorder is turned off, but
the [FRAME RATE] setting is retained.
• Flicker correction has no effect.
• You cannot record sound.
• The auto focus function is not supported.
• Shutter speeds slower than the frame rate cannot
be selected.
• Super Slow Motion recording is not supported
when the file format is XAVC S 4K.
• For details about Super Slow Motion
limitations, see "Slow & Quick Motion and
Super Slow Motion recording limitations"
(p. 152).
Reviewing the most recently
recorded scene (Last Scene
Review)
You can review the most recently recorded
scene on the LCD screen.
You can assign this function to an ASSIGN
button.
For details about function assignment
operation to an ASSIGN button, see
"Assigning functions to the ASSIGN
buttons" (p. 64).
Advertisement
Table of Contents
