Table of Contents
Advertisement
Removing and installing components
NOTE:
The images in this document may differ from your computer depending on the configuration you ordered.
Recommended tools
The procedures in this document may require the following tools:
● Phillips screwdriver #0
● Phillips screwdriver #1
● Torx #5 (T5) screwdriver
● Plastic scribe
Screw list
NOTE:
When removing screws from a component, it is recommended to note the screw type, the quantity of screws, and
then place them in a screw storage box. This is to ensure that the correct number of screws and correct screw type is
restored when the component is replaced.
NOTE:
Some computers have magnetic surfaces. Ensure that the screws are not left attached to such surfaces when
replacing a component.
NOTE:
Screw color may vary with the configuration ordered.
Table 1. Screw list
Component
Side cover
M.2 2230 solid-state drive heat sink
M.2 2230 solid-state drive
WLAN card
Heat sink
System board
Screw type
Quantity
Thumb screw (#6-32)
1
Captive screw
2
M2x3.5
1
M2x3.5
1
Captive screw
4
M3x4
2 (1 for M.2
WiFi standoff and
M3x5
1 for M.2 SSD
standoff)
6 (5 for system
board and 1 for
speaker holder)
Removing and installing components
2
Image
NA
NA
9
Advertisement
Table of Contents
