Table of Contents
Advertisement
Replace Chassis Components
----------------------
RP reloaded Wed May 31 16:03:53 2023: 1 day, 5 hours, 40 minutes ago
Active node booted Wed May 31 16:03:53 2023: 1 day, 5 hours, 40 minutes ago
Standby node boot Wed May 31 16:04:06 2023: 1 day, 5 hours, 40 minutes ago
Standby node last went not ready Wed May 31 16:07:06 2023: 1 day, 5 hours, 37 minutes
ago
Standby node last went ready Wed May 31 16:08:53 2023: 1 day, 5 hours, 35 minutes ago
Standby node last went not NSR-ready Wed May 31 16:06:49 2023: 1 day, 5 hours, 37 minutes
ago
Standby node last went NSR-ready Wed May 31 16:13:26 2023: 1 day, 5 hours, 30 minutes
ago
There have been 0 switch-overs since reload
Active node reload "User initiated chassis reload"
Standby node reload "User initiated chassis reload"
2. Perform the graceful shutdown of the MPA. Run the shutdown location location command in admin
EXEC mode, which gracefully shuts down MPA to prevent any of the file systems from being corrupted.
3. Verify that the MPA Status LED for the slot that you specified turns off. Also, you can verify that the
card is in the powered off state by running the show platform command.
4. To remove the MPA from the chassis, loosen the captive screws (marked as 1 in the image) on the MPA.
5. Press the tab down (marked as 2 in the image).
6. Pull the ejector lever away from the MPA (marked as 3 in the image).
7. Grasp the MPA and pull the MPA from the chassis (marked as 4 in the image). (You have already
disconnected the cables from the MPA.)
Figure 72: Remove an MPA
1
3
Rotate the captive screw to loosen the MPA.
Pull the ejector lever away from the MPA.
2
Press the tab down.
Hardware Installation Guide for Cisco 8600 Series Routers
Remove a Modular Port Adapter
101
Advertisement
Table of Contents
