Page 2
Welcome! Dear Customer, Thank you for choosing the Beko product. We want your product, manufactured with high quality and technology, to offer you the best efficiency. Therefore, carefully read this manual and any other documentation provided before using the product.
Table of Contents 1 Safety Instructions......General Safety ....... Electrical Safety......Product Safety ....... Intended Use........Child, Vulnerable Persons and Pet Safety........Transportation Safety ....2 Environmental Instructions..Waste Directive......2.1.1 Compliance with the WEEE Dir- ective and Disposing of the Waste Product ......
1 Safety Instructions • This section includes the General Safety safety instructions necessary • This product can be used by to prevent the risk of personal children 8 years of age and injury or material damage. older, and people who are un- •...
• This product is not intended • Call the authorized service for for use by persons (including the installation of the product children) with limited physical, to be used. The warranty term sensory or mental capacity or starts after this process. without knowledge or experi- •...
facturer, the manufacturer's Product Safety service centre or a similar • Height between the bottom qualified person. surface of your hood and the • If the cable is damaged, con- top surface of the oven should tact our nearest service centre be no less than 650 mm for and have a new one installed.
Page 7
• Do not expose the appliance to • If there is another appliance open flame. It may cause the operating with fuel oil or oil accumulating in the filter to gaseous fuels in the environ- catch fire. Do not operate the ment, adequate ventilation of appliance without a filter.
• There is a risk of fire if clean- performed by children unless ing is not carried out in accord- there is someone overseeing ance with the instructions. them. • There should not be open fire • This product should not be under the hood.
tightly with tape to prevent the • Check the overall appearance removable or moving parts of of the product for any damage the product and the product that may have occurred during from getting damaged. transportation. 2 Environmental Instructions 2.1 Waste Directive administration about these collection points.
3 Your product 3.1 Product Introduction 1 Hood body 2 Hood glass lid 3 Damper 4 Aluminium filter 5 Lamp 6 Lamp 7 Aluminium filter lock 8 Control panel Wall mounting part Dependent on the model. It may not be avail- able on your product.
Page 11
Air router Flue connection adapter Covers to prevent reverse airflow EN / 11...
3.3 Technical Specifications Product external dimensions (height/width/depth) (mm) min. 910 - max. 1138 /595 /419 Voltage/Frequency 220-240 V ~1N; 50/60 Hz Total power consumption max. 300 W Suction power 700-720 m3/h Diameter of air outlet pipe 120-150 mm Control Model A 3 levels Model B 3 levels + 1 booster...
4 Using the Hood The hood has an engine with various MODEL C speeds. For a good performance, we re- commend using low speeds under normal conditions and high speeds in case of strong odour and vapour condensation. The program is cancelled if power is cut when any program in your hood is active.
Page 14
In intensive ventilation mode, when You can only change the light col- any speed key is touched, it returns our shade while the lamp has high to that speed level and continues to light intensity. operate. In the event of a power outage, your Operating the lamp hood will remember the colour 1.
Page 15
tion. When you touch the Speed 2 key for If the ambient temperature differ- more than 3 seconds, aluminium filter fill ence occurs even when the hob is warning is reset and the lamp is turned off. not operating while the automatic mode is active, the temperature The warning is not cancelled if the sensor in the product will detect the...
If you run your hood at any speed If you turn off the warning without level with the carbon filter fill warn- replacing the carbon filter, the oper- ing, the warning will not appear for ating time of 100 hours is reset and as long as the hood is running.
2. Gently pull the filter towards you first In carbon-filtered usage, the sound and pull it upwards to remove it from its level increases and the flow rate slot. performance decreases. Removing carbon filters 1. Open the glass cover of the hood and re- move the aluminium filter.
Page 18
Hood light is not on. • Hood lamp may be faulty. >>> Contact your local dealer where you purchased your product or the Customer Service, and ensure that the lamp is replaced. • There may be no electricity. >>> Ensure the mains is operational and check the fuses in the fuse box.