Table of Contents
Advertisement
Figure 149. Removing the Serial COM port
2. Install the filler bracket if not replacing the serial COM port.
Next steps
1.
Replace the serial COM
Installing the serial COM port
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the 2U air
shroud.
4. Remove the
Riser
3.
NOTE:
The serial COM port is supported only on slot 5 of the expansion card riser 3 .
NOTE:
The procedure to install the serial COM port is the same for Rear Accessed and Front Accessed configurations.
Steps
1. Open the latch on the expansion card riser and remove the filler bracket from the expansion card riser.
2. Slide the serial COM port into the expansion card riser and close the latch.
174
Installing and removing system components
port.
Safety
instructions.
Before working inside your
system.
Advertisement
Table of Contents
