Table of Contents
Advertisement
Installing the Cisco MDS 9710 and MDS 9718 Series Switch on a Four-Post Rack or Cabinet
e. Rotate the levers away from the front of the module and hold them while sliding the module all the way into the
slot.
f. Simultaneously rotate both levers to the front of the module. They click when locked to the front of the module.
Step 10
If you have removed any fan modules before moving the chassis, reinstall each one in the chassis as follows:
a. Holding each of the two handles on the fan module with your two hands, align the fan module to an open fan module
slot.
Note
b. Slide the fan module into the slot until the front of the fan module comes in contact with the rear of the chassis.
Note
c. Screw in the four captive screws to the chassis and tighten each screw to 8 in-lb (0.9 N·m).
Step 11
If you have removed any power supplies before moving the chassis, reinstall each one as follows:
a. Determine which power supply slots to fill and ensure that each of those slots is open.
If you are using the combined or power supply redundancy mode, you can use any slot for the power supply that
you are installing.
If you are using the input-source or full redundancy mode, you must group the power supplies that are to be connected
to the same grid on either the left or right power supply slots in the chassis (that is, place the power supplies for
grid A in slots 1 or 2 or both slots and place the power supplies for grid B in slots 3 or 4 or both slots).
For information on the power supplies supported by Cisco MDS 9700 series switches, see the
under the Product Overview chapter.
b. Place one hand on the front of the power supply and place your other hand under it to support its weight.
c. Align the power supply to an open power supply slot.
Note
Step 12
Slide the power supply all the way into the slot until its release handle clicks and the module stops.
Installing the Cisco MDS 9710 and MDS 9718 Series Switch on a Four-Post
Rack or Cabinet
This section is applicable to the Cisco MDS 9710 and Cisco MDS 9718 switches.
Before You Begin
• Verify that the chassis shipment is complete and undamaged.
• Verify that a rack or cabinet is installed and secured to the subfloor.
Cisco MDS 9700 Series Switches Hardware Installation Guide
90
The two alignment brackets on top of the fan module should align to two tracks at the top of the slot.
The two alignment pins on the fan module (on the top and one on the bottom) should go into holes in
the chassis and the four captive screws on the fan module should align to screw holes in the chassis.
The alignment bracket on top of the power supply should align to a track at the top of the slot and a
bar at the bottom of the power supply should be guided by a track at the bottom of the slot.
Installing the Cisco MDS 9700 Series Switches
Power Supply
section
Advertisement
Table of Contents
Troubleshooting
