Table of Contents
Advertisement
Available languages
Available languages
Introduction..................................................................... 2
Safety..............................................................................5
Assembly...................................................................... 13
Operation...................................................................... 17
Maintenance................................................................. 26
Service..........................................................................29
Owner responsibility
WARNING:
stone by methods such as cutting, grinding
or drilling, especially during dry operation,
generates dust that comes from the material
being processed, which frequently contains
silica. Silica is a basic component of sand,
quartz, brick clay, granite and numerous
other minerals and rocks. Exposure to
excessive amount of such dust can cause:
Respiratory disease (affecting your ability
to breathe), including chronic bronchitis,
silicosis and pulmonary fibrosis from
exposure to silica. These diseases may be
fatal;
Skin irritation and rash.
Cancer according to NTP* and IARC* */
National Toxicology Program, International
Agency for Research on Cancer.
Take precautionary steps:
Avoid inhalation of and skin contact with
dust, mist and fumes.
Wear and ensure that all bystanders
wear appropriate respiratory protection such
as dust masks designed to filter out
microscopic particles. (See OSHA 29 CFR
Part 1926.1153)
To minimize dust emissions, use water
to bind the dust, when feasible. If dry
operation is necessary, use an appropriate
dust extractor.
2
Contents
Introduction
Processing of concrete and
Troubleshooting............................................................ 29
Transportation, storage and disposal........................... 31
Technical data.............................................................. 32
Accessories.................................................................. 32
Supplier's Declaration of Conformity for K 540i............ 33
Registered trademarks................................................. 35
It is the owner's/employer's responsibility that the
operator has sufficient knowledge about how to use the
product safely. Supervisors and operators must have
read and understood the Operator's Manual. They must
be aware of:
•
The product's safety instructions.
•
The product's range of applications and limitations.
•
How the product is to be used and maintained.
National/Local regulations could restrict the use of this
product. Find out what regulations are applicable where
you work before you start using the product.
Product description
The power cutter is a portable handheld cut-off machine.
The product is energized by a battery.
The product can be used for wet and dry operations.
Wet cutting on page 24 and Dry cutting on
Refer to
page 24 .
The product has embedded connectivity. Refer to
Embedded connectivity on page 4 .
Intended use
The product is used to cut hard materials as concrete,
masonry, stone and steel. Do not use the product
for other tasks. The product must only be used by
professional operators with experience.
Work is constantly in progress to increase your safety
and efficiency during operation. Speak to your servicing
dealer for more information.
Note:
National/Local regulations could restrict the use
of this product.
1960 - 002 - 25.08.2023
Advertisement
Chapters
Table of Contents
