Table Of Contents; Unpacking; Transporting; Sound Data - Husqvarna Soff-Cut 2000 Operator's Manual
Hide thumbs
Also See for Soff-Cut 2000:
- Operator's manual (47 pages) ,
- Operator's manual (148 pages) ,
- Operator's manual (104 pages)
Table of Contents
Advertisement
CONTENTS
Content
Table of contents ................................
Unpacking ..................................................
Transporting ...............................................
Sound Data ................................................
ntroduction, personal safety ...................... 3
Registration of the product ..................... 4
General safety message ............................
Safety warnings .........................................
Excel series blades ...................................
Blade and skid plate installation ................
What is what? ............................................
Operating instructions ...............................
Fuel and fuel safety warnings .................
Recommended fuels .................................
Recommended oils ...............................
Other maintenance ..............................
Sawing contraction joints .......................
Maximizing the Soff-Cut system ...............
Troubleshooting .........................................
Technical specifications .............................
Conformity certificates ...............................
Warranty ....................................................
Your 2000 saw has been shipped from the factory thoroughly
Page
inspected. Only minimal assembly is required to start using the
2
saw. Remove the saw from the container using proper lifting
2
techniques. Discard or recycle the packing material per your
2
regional laws. In your container will be the 2000 saw, blade
2
shaft wrench, spark plug wrench, an owner's manual, an en-
gine owner's manual, a part list, a warranty card, a joint protec-
tor sample pack and a ramp for unloading the saw. Raise the
saw to its full height by pressing down on the handle bar. Place
the unloading ramp at the edge of the container and roll the
4
saw out of the container. Lower the saw by pressing down on
the handle bar and squeezing the lever on the handle bar.
5
NOTE: No diamond cutting blade or skid plate is included
6
with the saw. Purchase the appropriate Husqvarna Excel
6
Series 9 or 10 inch blade from your local Husqvarna Con-
struction Product dealer.
7
8
The 2000 saw weights approximately 272 pounds (124 ki-
9
lograms) when ready to use . Use safe lifting practices when
9
handling the saw. Always remove the diamond blade when
9
transporting the saw. Always transport the saw with a skid
plate installed. Fold the guide arm back. The saw can be lifted
10
from the center hook on the roll cage. Always store and trans-
port the saw in a completely lowered position and secured
11
from moving.
12
13
14
15
15
16
According to Standard ISO 3744:1998 and Directive 2000/14/
EC for environmental sound level and according to Standard
ISO 11201:1995 for sound level at the operator's position, the
2000 saw emits the following:
2
UNPACKING
TRANSPORTING
Handle bar
Lifting point
Front guide
Rear guide
CAUTION
Only use the center hook on the
roll cage when lifting the 2000.
SOUND DATA
Sound power level
Sound pressure level
WARNING
Always wear safety approved hearing protection.
Roll cage
Lwa 101 dB (A)
Lpa 87 dB (A)
Hide quick links:
Advertisement
Table of Contents
