Table of Contents
Advertisement
3.
Replace the GPU fan
4. Follow the procedure listed in
Installing the A100 baseboard
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the GPU fan
4.
Remove the GPU
tray.
5.
Remove the GPU top
NOTE:
For heatsink installation, it is required to use an ESD-Safe Torque screwdriver holding a Phillips 1 bit with a narrow
shaft that is at least 15cm (6 inches) of length.
Steps
1. Align the GPU baseboard with the guiding pins and insert it onto the GPU tray in a top-to-bottom direction.
Figure 153. Installing the A100 baseboard
2. Using a Torx 15 screwdriver, hand-tighten the 16 captive screws down in the order shown. Then, utilize the Torque
screwdriver in the same order and set the final torque at 6.0 ± 4% lbf-in or 0.68 ± 4% N-m.
cage.
After working inside your
Safety
Before working inside your
cage.
cover.
system.
instructions.
system.
Installing and removing system components
175
Advertisement
Table of Contents
