Table of Contents
Advertisement
Figure 180. Removing the rear I/O board
Next steps
1.
Replace the LOM card and rear I/O
Installing the LOM card and rear I/O board
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the cooling fan cage
4.
Remove the air
shroud.
5. Observe and disconnect the cables from the connectors on the power distribution board.
6.
Remove the PSU
cage.
7.
Remove the BOSS
cage.
NOTE:
The procedure to install the liquid cooling rear I/O board and rear I/O boards is same.
Steps
1. Align the connectors and slots on the LOM card or rear I/O board with the connector and standoffs on the system board.
2. Press the LOM card or rear I/O board until firmly seated on the system board connector.
3. Using a Phillips 2 screwdriver, secure the LOM card or rear I/O board to the system board with screws.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
198
Installing and removing system components
board.
Safety
instructions.
Before working inside your
assembly.
system.
Advertisement
Table of Contents
