Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Beko DIN 1400 XN
Summary of Contents for Beko DIN 1400 XN
- Page 1 Dishwasher...
- Page 2 Please keep these documents in a safe place for later reference. This operating manual has been written for several different machines, and some of the features mentioned here may not apply to your particular model.
-
Page 3: Table Of Contents
TABLE OF CONTENTS 1 Getting To Know Your Machine 3 6 Troubleshooting: View of the Machine What to do if the dishwasher will not Technical Specifications The cleaning results are unsatisfactory 2 Safety Instructions Service Before Installation Before First Use... -
Page 4: Product View And Parts
� � �� � � � � � Upper dish basket with shelf �� Guide rail for the upper dish basket Salt container Cutlery basket Detergent dispenser Door Control panel Filters Lower sprayer arm 10. Lower basket 11. Upper sprayer arm 12. -
Page 5: Technical Specifications
Permitted water pressure: 0,3 –10 prior notice. bar (= 3 – 100 N/cm² = 0,01-1,0Mpa) Electrical connection: 220-240 Volts, Note for Testing Institutes 10 Amps (see type plate) The necessary information for... -
Page 6: For Daily Operation
• manufacturers of the detergents. Do not pull on the cable – pull on • Never leave children unsupervised the plug. Turn off the water supply while the appliance is open, as tap. the appliance may still contain detergent leftovers. -
Page 7: Directions For Assembly
Choose a suitable location for your appliance, please check it for possible dishwasher. Take care to ensure transit damage. that the appliance is stable on a level surface. • If the appliance is damaged, please Unevenness in the floor can be contact your supplier. -
Page 8: Water Connection
Water connection tap with a ¾ inch external thread. If • required, use a filter insert to filter There are two different types of deposits from the pipes. water inlet hoses: - Cold water inlet hose (up to Check that the connection does not 25°C) -
Page 9: Water Drainage
Please refer to the type plate for information on current type, mains voltage, and fuse protection. 1011 The type plate is located on the inside of the door. The mains plug must be freely accessible after installation. Power cables and insulated cables must not be accessible (exposed) after installation. -
Page 10: Using Your Dishwasher
Disable any door and electronic equipment. This is locks. indicated by a symbol to be found on Using Your Dishwasher Important salt. These types of salt do not dissolve The electricity and water connections... -
Page 11: When Operating For The First Time
When operating for the first � time: Pour 1 litre of water into the salt container (Fig. C). Pour the salt into the container with the aid of the salt funnel provided (Fig. D). Pour in enough salt to fill the container. -
Page 12: Filling The Rinse Aid Dispenser
Only use rinse aid designed for use in dishwashers. Note 1013 � If you use “2 in 1” or “3 in 1“ detergents / tablets, you do not need an additional rinse aid. Open the rinse aid dispenser by �... -
Page 13: Detergent
Please use detergents produced recommend filling the detergent specially for the dishwashers in your container up to the 25 cm³ mark. When machine. the dishes are less dirty, it is generally sufficient to fill the detergent up to the Keep the opened detergent packages 15 cm³... -
Page 14: Multipurpose Detergents
After the empty washing review the New products of the detergent user manual and readjust the water producers what they call as hardness level so as to suit your water “Multipurpose Detergent” can act as supply. water softening salt and/or rinse aid in addition to acting as a detergent. -
Page 15: Suggestions For Loading The Dishwasher
You can either fold each notes regarding dishes which are section (1, 2, 3, 4) individually or, all at suited to the dishwasher. once, to create a large empty space. Simply press the handgrips (A) and Only in this manner will you obtain fold them down”... - Page 16 You can either fold each section (1, 2) individually or, all at once, to create a large empty space. Simply press the handgrips (A) and fold them down”...
- Page 17 Small cutlery basket sections also fit into the upper basket. � To do this, turn the lock on the handle to the right (A). Pull the smaller cutlery basket upwards � and out of its holders (B).
- Page 18 You can also use this insert in the lower basket for glasses and long- handled cutlery / utensils. If you do not need the insert, fold the rack upwards at the angle shown (A). Push the entire insert upwards (B).
-
Page 19: Loading Suggestions
1021 dishwasher, even if it is fully loaded. The height of the upper basket was set to its lowest position at the factory. � To lift the upper basket to the “high” (A) position, hold it on one side and carefully pull it upwards. - Page 20 Height setting with empty basket (depends on the model) In this model, the height setting of the upper basket may be changed using the wheels which are mounted at two different heights. Release the latches on both the right �...
- Page 21 When you need to place the bulky pieces into the upper basket, disconnect the lug of the glass support from the bar of the basket where it is attached to. Thus, you will acquire a wider place. Upper Basket Drawer...
-
Page 22: How To Clean Your Dishwasher
Cleaning your machine at regular Warning intervals ensures longer product life Do not operate your dishwasher and reduces the risk of reccurring without a filter. Ensure that your filters problems. are correctly installed. Clean the filters regularly. Warning Always unplug the machine and turn off the water supply before cleaning. -
Page 23: Cleaning The Spray Arms
Cleaning the filter inset in the water inlet hose (depending on the model) Dirt or calcium residue may block the Dirt from deposits in the water pipes is nozzles on the spray arms. For this prevented by a filter in the water inlet reason, regularly check the spray hose. -
Page 24: Troubleshooting
After washing the filter system, replace them as shown in the manual. Clogged impeller holes Take out and clean the impellers from time to time as shown in the figure. Overloading the baskets Do not overload the baskets in excess of their capacity... - Page 25 Unloading the machine right after dishwashing Do not unload your dishwasher right after washing process is completed. Slightly open the door and wait for evacuation of the inside steam for a while. Unload the dishes after the pieces cool down to a touchable level. Start unloading process from the lower basket.
- Page 26 Use the supplied salt funnel while filling in softening salt. Make sure that the salt box cover is tightly closed after finishing the filling process. Run a washing program to clean up the salts spilled in the machine. Recheck the salt box cover after the program is completed.
- Page 27 Use the supplied salt funnel while filling in softening salt. Make sure that the salt box cover is tightly closed after finishing the filling process. Run a washing program to clean up the salts spilled in the machine. Recheck the salt box cover after the program is completed.
- Page 28 Keep them in a closed container, if possible. For ease- of-storing, we recommend you to use tablet detergents. Clogged impeller holes Take out and clean the impellers from time to time as shown in the figure. 1043 Water Remained In The Dishwashing...
-
Page 29: Service
Spilling rinse aid in the machine while filling Take care that rinse aid is not spilled in the machine when you are filling it. Clean any spilled amount with the help of a tissue paper/towel. Leaving the rinse aid lid open or not closing it Rinse aid compartment should always be closed as shown in the manual after it is filled with rinse aid. - Page 30 17 1344 0100-02...