Cisco 7301 Installation And Configuration Manual page 55
Configuration guide
Hide thumbs
Also See for 7301:
- Regulatory compliance and safety information manual (70 pages) ,
- Manual (111 pages) ,
- Quick start manual (35 pages)
Table of Contents
Advertisement
Chapter 2
Rack-Mounting, Tabletop Installation, and Cabling
c.
Insert the –V lead into the plug as shown in
the plug.
If you have a dual DC power supply, repeat Step 4 for the second plug.
Step 5
Step 6
Insert the DC plug into the DC power connector on the chassis. If you have a dual DC power supply,
insert the second DC plug into the DC power connector.
Switch the circuit breaker to the on position.
Step 7
Press the power switch to turn on the router.
Step 8
For information on Cisco 7301 product specifications and power supply, refer to Cisco 7301 Router Data
Sheet at the following URL:
https://www.cisco.com/en/US/prod/collateral/routers/ps352/ps4972/product_data_sheet09186a008014
611a.html
After powering off the router, wait a minimum of 30 seconds before powering it on again.
Note
This completes the procedure for connecting DC-input power. Your installation is complete. Proceed to
Chapter 3, "Starting and Configuring the Router,"
OL-5418-07
Figure
2-19, and tighten the screw to hold the lead to
to start the router and to perform a basic configuration.
Cisco 7301 Installation and Configuration Guide
Connecting Power
2-25
Advertisement
Chapters
Table of Contents
Troubleshooting
