Removing And Installing The Sodimms - Cisco 7301 Installation And Configuration Manual
Configuration guide
Hide thumbs
Also See for 7301:
- Regulatory compliance and safety information manual (70 pages) ,
- Manual (111 pages) ,
- Quick start manual (35 pages)
Table of Contents
Advertisement
Chapter 4
Installing and Removing Field-Replaceable Units
Step 4
Remove the Cisco 7301 router from the rack, if it is rack-mounted.
Figure 4-3
1
1 Captive installation screws
Turn the Cisco 7301 so that the back is facing you.
Step 5
Using a Phillips screwdriver, loosen the three captive installation screws holding the cover to the chassis.
Step 6
Pull the cover toward you, away from the front of the router, and lift off the cover.
Step 7
Proceed to the following sections for replacement instructions:
•
•
Removing and Installing the SODIMMs
This information in this section provides instructions for replacing a DDR-SDRAM SODIMM and is
included for future use. The memory configuration you ordered is installed in the Cisco 7301 router.
During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly
Warning
touch the backplane with your hand or any metal tool, or you could shock yourself. Statement 94
OL-5418-07
Removing the Cover
1
Removing and Installing the SODIMMs, page 4-5
Replacing the Cover and Powering On the Router, page 4-7
Removing and Installing the SODIMMs
1
Cisco 7301 Installation and Configuration Guide
4-5
Advertisement
Chapters
Table of Contents
Troubleshooting
