Table of Contents
Advertisement
Chapter 2 Catalyst 2350 Cisco IOS Commands
Would you like to enter basic management setup? [yes/no]: yes
Configuring global parameters:
Enter host name [Switch]:host-name
The enable secret is a password used to protect access to
privileged EXEC and configuration modes. This password, after
entered, becomes encrypted in the configuration.
Enter enable secret: enable-secret-password
The enable password is used when you do not specify an
enable secret password, with some older software versions, and
some boot images.
Enter enable password: enable-password
The virtual terminal password is used to protect
access to the router over a network interface.
Enter virtual terminal password: terminal-password
Configure SNMP Network Management? [no]: yes
Community string [public]:
Current interface summary
Any interface listed with OK? value "NO" does not have a valid configuration
Interface
Vlan1
GigabitEthernet0/1
GigabitEthernet0/2
<output truncated>
Port-channel1
Enter interface name used to connect to the
management network from the above interface summary: vlan1
Configuring interface vlan1:
Configure IP on this interface? [yes]: yes
IP address for this interface: ip_address
Subnet mask for this interface [255.0.0.0]: subnet_mask
Would you like to enable as a cluster command switch? [yes/no]: yes
Enter cluster name: cluster-name
The following configuration command script was created:
hostname host-name
enable secret 5 $1$LiBw$0Xc1wyT.PXPkuhFwqyhVi0
enable password enable-password
line vty 0 15
password terminal-password
snmp-server community public
!
no ip routing
!
interface GigabitEthernet0/1
no ip address
!
interface GigabitEthernet0/2
no ip address
OL-19055-01
IP-Address
OK? Method Status
172.20.135.202
YES NVRAM
unassigned
YES unset
unassigned
YES unset
unassigned
YES unset
up
up
up
up
Catalyst 2350 Switch Command Reference
setup
Protocol
up
up
down
down
2-217
Advertisement
Chapters
Table of Contents
