Table of Contents
Advertisement
show udld
show udld
Use the show udld user EXEC command to display UniDirectional Link Detection (UDLD)
administrative and operational status for all ports or the specified port.
Syntax Description
interface-id
| begin
| exclude
| include
expression
Command Modes
User EXEC
Command History
Release
12.2(46)EY
Usage Guidelines
If you do not enter an interface-id, administrative and operational UDLD status for all interfaces appear.
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
do not appear, but the lines that contain Output appear.
Examples
This is an example of output from the show udld interface-id command. For this display, UDLD is
enabled on both ends of the link, and UDLD detects that the link is bidirectional.
the fields in this display.
Switch> show udld gigabitethernet0/1
Interface gi0/1
---
Port enable administrative configuration setting: Follows device default
Port enable operational state: Enabled
Current bidirectional state: Bidirectional
Current operational state: Advertisement - Single Neighbor detected
Message interval: 60
Time out interval: 5
Catalyst 2350 Switch Command Reference
2-366
show udld [interface-id] [ | {begin | exclude | include} expression]
(Optional) ID of the interface and port number. Valid interfaces include
physical ports and VLANs. The VLAN range is 1 to 4094.
(Optional) Display begins with the line that matches the expression.
(Optional) Display excludes lines that match the expression.
(Optional) Display includes lines that match the specified expression.
Expression in the output to use as a reference point.
Modification
This command was introduced.
Entry 1
Expiration time: 146
Device ID: 1
Current neighbor state: Bidirectional
Device name: Switch-A
Port ID: Gi0/1
Neighbor echo 1 device: Switch-B
Neighbor echo 1 port: Gi0/2
Message interval: 5
CDP Device name: Switch-A
Chapter 2 Catalyst 2350 Cisco IOS Commands
Table 2-21
describes
OL-19055-01
Advertisement
Chapters
Table of Contents
