Table of Contents
Advertisement
Chapter 2 Catalyst 2350 Cisco IOS Commands
Command Modes
Global configuration
Command History
Release
12.2(46)EY
Usage Guidelines
Specify the host (NMS) that receives the traps by using the snmp-server host global configuration
command. If no trap types are specified, all trap types are sent.
When supported, use the snmp-server enable traps command to enable sending of traps or informs.
Informs are not supported in SNMPv1.
Note
To enable more than one type of trap, you must enter a separate snmp-server enable traps command
for each trap type.
Examples
This example shows how to send VTP traps to the NMS:
Switch(config)# snmp-server enable traps vtp
You can verify your setting by entering the show vtp status or the show running-config privileged
EXEC command.
Related Commands
Command
show running-config
snmp-server host
OL-19055-01
Modification
This command was introduced.
Description
Displays the operating configuration. For syntax information, use this link to
the Cisco IOS Release 12.2 Command Reference listing page:
http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/prod_command
_reference_list.html
Select the Cisco IOS Commands Master List, Release 12.2 to navigate to
the command.
Specifies the host that receives SNMP traps.
snmp-server enable traps
Catalyst 2350 Switch Command Reference
2-385
Advertisement
Chapters
Table of Contents
