Cisco WS-C3560E-24PD-E Command Reference Manual page 149

Catalyst 3560 series switch

Table of Contents

Catalyst 3560 Switch Cisco IOS Commands

Follow these guidelines when you use the interface port-channel command:

For a complete list of configuration guidelines, see the "Configuring EtherChannels" chapter in the

software configuration guide for this release.

This example shows how to create a port-channel interface with a port channel number of 5:

Switch(config)# interface port-channel 5

You can verify your setting by entering the show running-config privileged EXEC or show

etherchannel channel-group-number detail privileged EXEC command.

Related Commands

channel-group

show etherchannel

show running-config

If you want to use the Cisco Discovery Protocol (CDP), you must configure it only on the physical

port and not on the port-channel interface.

Do not configure a port that is an active member of an EtherChannel as an IEEE 802.1x port. If

IEEE 802.1x is enabled on a not-yet active port of an EtherChannel, the port does not join the

EtherChannel.

Assigns an Ethernet port to an EtherChannel group.

Displays EtherChannel information for a channel.

Displays the current operating configuration. For syntax information, select

Cisco IOS Configuration Fundamentals Command Reference, Release 12.2

> File Management Commands > Configuration File Management

interface port-channel

Catalyst 3560 Switch Command Reference

Show Quick Links

Table of Contents