Table of Contents
Advertisement
Chapter 2
Managing the GSS from the CLI
Replacing the Standby GSSM in the Network
OL-10410-01
At the CLI of each GSS, enter the gss enable command to enable your
e.
GSS device as a GSS and direct it to the primary GSSM. Specify either
the domain name or the network address of the primary GSSM. See the
"Replacing a GSS in the Network"
enable command.
You may want to perform this step on one GSS device at a time to
Note
minimize disruptions on your GSS network.
gss3.example.com# gss enable gss gssm1.example.com
Register the standby GSSM and each GSS device with the new primary
f.
GSSM. See the
section in
Chapter 1, Managing GSS Devices from the
You can now use the replacement primary GSSM in your GSS network.
To replace a malfunctioning standby GSSM in your GSS network, perform the
following steps:
1.
Determine if you can wait for the replacement standby GSSM or if you
require an immediate configuration change in your GSS network as follows:
•
If yes, wait until the replacement GSS is available and configure it as the
standby GSSM. Proceed to Step 5.
If no, configure an available GSS device as the standby GSSM. Proceed to
•
Step 2.
Log in to the CLI of the GSS and enable privileged EXEC mode.
2.
gss3.example.com> enable
gss3.example.com#
Stop the GSS software running on the GSS by entering the following
3.
command:
gss3.example.com# gss stop
Disable the GSS to remove the existing configuration and return the GSS
4.
device to an initial state by entering the following command:
Replacing GSS Devices in Your GSS Network
section for details about the gss
"Activating GSS Devices from the Primary GSSM"
Cisco Global Site Selector Administration Guide
GUI.
2-37
Hide quick links:
Advertisement
Table of Contents
