Cisco SFS-7012 - SFS InfiniBand Server Switch 7012 Hardware User's Manual page 46
Server switch
Hide thumbs
Also See for SFS-7012 - SFS InfiniBand Server Switch 7012:
- Hardware user's manual (176 pages)
Table of Contents
Advertisement
Figure 2-11 SFS 7012 Chassis Front View
Figure 2-12 SFS 7012 Chassis Back View
Connect a Category 5 or 6 (Cat 5/6) Ethernet cable to one of the RJ-45 connectors on the SFS 7012.
Step 1
Connect the other end of the Cat 5/6 to the OOB LAN workstation. Refer to
connector(s) to use:
Connect the switch to IB-enabled hosts using 4X-to-4X IB cables.
Step 2
Make sure all cables latch securely into the corresponding port connectors. If the IB cable connector is
Note
not properly oriented to fit onto the port receptacle (i.e., while attempting to insert the cable in the port),
do not twist the connector to achieve the correct orientation. Instead, reach back a few feet on the cable,
and twist the bulk cable to allow the connector to rotate to the proper orientation. Doing this prevents
all of the rotational forces from acting right at the connector terminations.
It is important to provide strain relief for the IB cable connector.
Caution
Cisco SFS 7012 InfiniBand Server Switch Hardware Users Guide
28
Leaf 11
Leaf 9
Leaf 7
Leaf 5
Leaf 3
Leaf 1
AC power inlet for power
supplies 1 to 3
RJ-45 for Spine 1
Leaf 12
Leaf 10
Leaf 8
Leaf 6
Leaf 4
Leaf 2
AC power inlet for power
supplies 4 to 6
RJ-45 for Spine 2
Figure 2-12
Chapter
for which RJ-45
OL-8787-04
Advertisement
Table of Contents
