Table of Contents
Advertisement
Cabling the CSS 11501
CSS 11501 Connectors and LEDs
Cisco 11500 Series Content Services Switch Hardware Installation Guide
2-4
The CSS 11501 has all connectors and LEDs on the chassis front panel.
illustrates the connectors and LEDs on the CSS 11501.For information on the
connector pinouts, refer to Appendix B,
Figure 2-1
CSS 11501 Connectors and LEDs
2
4
1
3
5b
STAT US
LINK /ACT
DUP LEX
LINK DPLX
CON SOL E
PCM CIA
10
11
5a
9
1
Bicolor status LED
(green and red)
2
Amber status LED
3
RJ-45 RS-232 Console connector
4
10-Mbps half-duplex Ethernet
management connector
5a PCMCIA slot 0 containing a flash
or hard disk
5b PCMCIA slot 1 (shown empty) for
optional installation of a second
flash or hard disk
1. The Ethernet Link/Act LED and Duplex LED are located at the top of each RJ-45 Ethernet
connector and are not visible in this illustration.
Chapter 2
Cable Connector
6
7
8
LINK DPLX
LINK DPLX
LINK DPLX
LINK DPLX
LINK DPLX
LINK DPLX
LINK DPLX
CI SC O 11
50 0
C O N T E
SER IES
1
N T
2
S E RV I C
GE
E S
3
LINK
S W I T C
H
10/ 100
4
5
6
7
8
10/ 100
6
7
8
9
10 PCMCIA slot cover
11 Recessed button (reserved for field
Cabling and Troubleshooting the CSS
Pinouts.
RJ-45 Ethernet
10BASE-T/100BASE-TX
connectors 1 through 8
SFP GBIC (optional)
Link LED for SFP GBIC
RJ-45 RS-232 Diag connector for
field service diagnostic use only.
(A connector cover is provided.
Removing the cover voids the
warranty.)
service use only)
Figure 2-1
1
78-16421-01
Advertisement
Table of Contents
Troubleshooting
