Table of Contents
Advertisement
Chapter 4
Management and Configuration
•
•
•
Advanced Settings
Available settings include the following:
•
•
•
•
•
•
•
•
•
•
•
OL-19276-01
Select or deselect Initiate DLC Establishment
If checked, the Cisco VG30D Voice Gateway will attempt to establish each LAP by sending
SABMEs on each commissioned channel.
Select or deselect Clear on Establish
If checked, the Cisco VG30D Voice Gateway will send a CRM on each LAP as it is established.
Channel Allocation - Low to High / High to Low
This dictates whether channels get allocated to calls starting at the highest or the lowest enabled
channel.
Proxy Diversion Service: If service is enabled and a call from the QSIG network to the DPNSS
network is diverted, the Cisco VG30D Voice Gateway will intervene to ensure that the diversion
takes place. If service is disabled, calls from the QSIG network that encounter diversion at a DPNSS
PBX are likely to fail. This setting does not affect calls from DPNSS, either to QSIG or transparently
over QSIG to other DPNSS extensions.
You can configure diversion service to act on behalf of all calls (All), a specific dialed number
(Exact), calls matching a part of the dialed number (Match) or calls that do not match (No Match)
a given part of a dialed number.
Proxy Divert Address Filter: The filter represents the digits against which the dialed number is
matched, if the Proxy Diversion Service is set to Exact, Match or No Match.
Operator Recall Timeout: This setting only applies if Proxy Diversion is enabled. If a call is
diverted by an Operator in the DPNSS network to a phone in the QSIG network, the phone to which
it has been diverted will ring for the number of seconds that is configured and then will revert to the
operator (unless answered). If the Operator Recall Timeout is disabled, the call will continue
ringing at the QSIG extension.
Enable ISDX VMS Emulation: Checking this setting allows extensions on QSIG PBXs to be
integrated into a Voice Mail System (VMS) that is hosted on an ISDX PBX.
ISDX VMS Diversion on No-reply Timer: See
ISDX Voice Messaging
Systems.
Default ISDX VMS Number: See
Messaging
Systems.
ISDX VMS Diversion Count Threshold: See
ISDX Voice Messaging
Systems.
Enable Supplementary String Generation: This setting adds any supplementary service strings to
the Selection field.
Enable Incoming Name Services: This setting allows DPNSS text strings to be mapped into Called
and Calling party names in QSIG.
Enable Divert Messages: This setting allows DPNSS text strings to be mapped into QSIG Diversion
service messages as names.
Enable Proxy Mapping of Calling Party Category: When Proxy Mapping of Calling Party
Category is enabled, the Cisco VG30D Voice Gateway will generate appropriate calling part
category elements from QSIG name elements.
DPNSS Message Waiting Implementations
DPNSS Message Waiting Implementations
DPNSS Message Waiting Implementations
Cisco VG30D Voice Gateway User Guide
DPNSS Configuration
and
and
ISDX Voice
and
4-5
Hide quick links:
Advertisement
Table of Contents
