Table of Contents
Advertisement
Back Panel Equipment
P1 and P2
The two amber Port LEDs are labelled P1 and P2. Together with the STATUS LEDs, they indicate unit
status. When the unit is operating normally and all is well, these LEDs turn on and off every few seconds
with all STATUS LEDs off.
When a problem exists, the Port LEDs will show the problem's location (P1 or P2, or if both P1 and P2
are lit, a major alarm exists). The STATUS LEDs will then indicate the problem. If more than one port
has a problem, they will be shown in a cycle of 5 seconds each.
Power
The Power LED has two functions. When power is applied, it comes on amber to indicate that the unit is in
self-test mode. When the self-test satisfactorily completes, it changes to green to indicate that the unit is
functioning correctly.
Back Panel Equipment
This section describes the
Figure
Figure 4
Ports
Ethernet
Use the 10/100 Base-T Port to connect to the IP Network to allow voice packets to be transmitted and
received and for a computer using a Web browser to communicate with the Cisco VG30D Voice Gateway
configuration and management interface.
Cisco VG30D Voice Gateway User Guide
2-4
Cisco VG30D Voice Gateway
4.
Rear View
Power Supply
Unit
Earth
DISCONNECT MAINS SUPPLY BEFORE REMOVING LID
NO USER SERVICEABLE PARTS
Ethernet
10/100 Base-T
110 -230 VAC
60 - 50Hz
380mA
FUSE
T2A H 250V
Fuse
Ethernet
Port
back panel ports and switches that are shown in
Serial
BNC Connectors
Number
(75 Ohm only)
Serial No. 3 2 7 7 1 9 5
Factory
POST
RJ45
BNC
RJ45
BNC
Impedance
Switch
POST
RJ45 Connectors
Switch
(120 Ohm only)
Impedance
Chapter 2
Alarm Port
Select
Craft Port
Factory
Craft
Craft
Switch
Craft Port
(RS232)
Switch
Installation
OL-19276-01
Hide quick links:
Advertisement
Table of Contents
