Configuring Snmp; Default Snmp Configuration - Cisco WS-C3550-12G Software Configuration Manual
Multilayer switch
Hide thumbs
Also See for WS-C3550-12G:
- User manual (436 pages) ,
- Manual (278 pages) ,
- Datasheet (19 pages)
Table of Contents
Advertisement
Configuring SNMP
Figure 18-1 SNMP Network
SNMP Manager
For information on supported MIBs and how to access them, see
Configuring SNMP
This section describes how to configure SNMP on your switch. It contains this configuration
information:
•
•
•
•
•
•
Default SNMP Configuration
Table 18-2
Table 18-2 Default SNMP Configuration
Feature
SNMP agent
SNMP community strings
SNMP trap receiver
SNMP traps
Catalyst 3550 Multilayer Switch Software Configuration Guide
18-4
Get-request, Get-next-request,
NMS
Get-bulk, Set-request
Get-response, traps
Default SNMP Configuration, page 18-4
Configuring Community Strings, page 18-5
Configuring Trap Managers and Enabling Traps, page 18-7
Setting the Agent Contact and Location Information, page 18-9
Limiting TFTP Servers Used Through SNMP, page 18-9
SNMP Examples, page 18-10
shows the default SNMP configuration.
Chapter 18
Network device
MIB
SNMP Agent
Appendix A, "Supported MIBs."
Default Setting
Enabled
Read-Only: Public
Read-Write: Private
Read-Write-all: Secret
None configured
None enabled
Configuring SNMP
78-11194-03
- Quick Links:
- Table of Contents
- Front Panel View
- Ip Addresses
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
