Using Editing Features; Enabling And Disabling Editing Features; Editing Commands Through Keystrokes - Cisco WS-C3550-12G Software Configuration Manual
Multilayer switch
Hide thumbs
Also See for WS-C3550-12G:
- User manual (436 pages) ,
- Manual (278 pages) ,
- Datasheet (19 pages)
Table of Contents
Advertisement
Using Editing Features
To disable the feature during the current terminal session, enter the terminal no history privileged
EXEC command.
To disable command history for the line, enter the no history line configuration command.
Using Editing Features
This section describes the editing features that can help you manipulate the command line. It contains
these sections:
•
•
•
Enabling and Disabling Editing Features
Although enhanced editing mode is automatically enabled, you can disable it.
To re-enable the enhanced editing mode for the current terminal session, enter this command in
privileged EXEC mode:
Switch# terminal editing
To reconfigure a specific line to have enhanced editing mode, enter this command in line configuration
mode:
Switch(config-line)# editing
To globally disable enhanced editing mode, enter this command in line configuration mode:
Switch(config-line)# no editing
Editing Commands through Keystrokes
Table 2-5
Table 2-5
Editing Commands through Keystrokes
Capability
Move around the command line to
make changes or corrections.
Catalyst 3550 Multilayer Switch Software Configuration Guide
2-6
Enabling and Disabling Editing Features, page 2-6
Editing Commands through Keystrokes, page 2-6
Editing Command Lines that Wrap, page 2-8
shows the keystrokes that you need to edit command lines.
1
Keystroke
Press Ctrl-B, or press the
left arrow key.
Press Ctrl-F, or press the
right arrow key.
Press Ctrl-A.
Press Ctrl-E.
Press Esc B.
Press Esc F.
Press Ctrl-T.
Chapter 2
Purpose
Move the cursor back one character.
Move the cursor forward one character.
Move the cursor to the beginning of the command line.
Move the cursor to the end of the command line.
Move the cursor back one word.
Move the cursor forward one word.
Transpose the character to the left of the cursor with the
character located at the cursor.
Using the Command-Line Interface
78-11194-03
- Quick Links:
- Table of Contents
- Front Panel View
- Ip Addresses
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
