Scanner Condition; Test - Panasonic KV-S2045C Service Manual
High speed color scanner kv-s2025c series; kv-su225c series; kv-s2045c series; kv-su245c series
Hide thumbs
Also See for KV-S2045C:
- Operating instructions manual (42 pages) ,
- Maintenance manual (2 pages)
Table of Contents
Advertisement
KV-S2025C Series / KV-SU225C Series / KV-S2045C Series / KV-SU245C Series
9.3.5.
Scanner Condition
Item
Sleep Mode
1. Click "Sleep Mode" on the main menu (Service Utility).
2. Set "Sleep Mode" to enable or disable by checking check-box.
3. Set "Waiting Time" (minutes) to change sleep mode.
4. Click "OK" to renew the setting.
Clean Imprinter
1. Click "Clean Imprinter" on the main menu to clean a ink jet head to
Warning Setting
1. Click "Warning Setting" on the main menu.
2. Change the parameters (Clean Roller Timing, Replace Roller Timing)
3. Click "OK" to renew the setting.
Set Default
1. Click "Set Default" on the main menu.
2. Click "Set Default" on "Set Default" dialog box to set "Sleep Mode
3. Click "Close" to get back to the main menu.
9.3.6.
Test
Item
LED
1. Click "LED" on the main menu.
2. Click "START" on LED dialog box to start LED Test continuously until
3. Click "Close" to get back to the main menu.
Key / Sensor
1. Click "Key / Sensor" on the main menu.
2. Check key and sensor status on Key / Sensor dialog box. (Each
3. Click "Close" to get back to the main menu.
Sensor Sensitive
1. Click "Sensor Sensitive Level" on the main menu.
Level
2. Check each sensor sensitive level on Sensor Sensitive Level dialog
3. Click "Close" to get back to the main menu.
Feed Motor
1. Click "Feed Motor" on the main menu.
2. Click "START" on "Feed Motor" dialog box to start to rotate Paper
3. Click "Close" to get back to the main menu.
Conveyor Motor
1. Click "Conveyor Motor" on the main menu.
2. Click "START" on "Conveyor Motor" dialog box to start to rotate
3. Click "Close" to get back to the main menu.
Operation
print.
on "Warning Setting" dialog box.
setting" and "Warning Setting to clean and replace roller" to default.
Operation
clicking "STOP".
sensor "ON" except for Door Sensor and STOP/START KEY means
paper existence in the scanner. Door Sensor "ON" means opening
the door.)
box.
Note
As required, click "Adjust" on Sensor Sensitive Level dialog
box to renew three sensors' (Waiting Sensor, Starting
Position Sensor, Ending Sensor) sensitive standard data to
judge whether paper exists or not correctly.
However, before this execution, the following cleaning is
needed.
a. Waiting Sensor and its reflector sheet
b. Starting Position Sensor and its reflector sheet
c. Ending Sensor and its reflector sheet
Feed Motor continuously until clicking "STOP".
Conveyor Motor continuously until clicking "STOP".
Default
Enable
15minutes
—
Clean:
20000
Replace:
300000
—
Default
—
—
—
—
—
64
Remarks
This item is available only in case
of installing Imprinter (Option) to
scanner KV-S2045C/SU245C
Series. (Not used to KV-
S2025C/SU225C Series)
Remarks
Changing periodically
(Green — Orange — Red —
Green —....)
- Quick Links:
- Error Code
- Troubleshooting -2
Hide quick links:
Advertisement
Table of Contents
