Table of Contents
Advertisement
Cable Installation
Important: If the cable is not fully attached, the unit may power intermittently.
1.
Insert the 15-pin D-type connector end of the cable into the socket on the
MS4980.
2.
Rotate the two screws clockwise to tighten.
3.
Gently pull on the cable strain relief to insure the cable is installed.
Cable Removal
Before removing the cable from the scanner, turn off power on the host system
and disconnect the power supply, if applicable.
1.
Rotate the two screws counter clockwise to loosen the screws.
2.
Pull gently on the strain-relief of the cable to remove it from the scanner.
4
Figure 2. Cable Installation
Figure 3. Cable Removal
- Quick Links:
- Configuration Modes
Hide quick links:
Advertisement
Table of Contents
