Appendix; Configuring The Switch With The Cli-Based Setup Program; Accessing The Cli - Cisco Catalyst 3850 Hardware Installation Manual
Catalyst 3850 series switch
Hide thumbs
Also See for Catalyst 3850:
- Hardware installation manual (146 pages) ,
- Manual (120 pages) ,
- Deployment manual (54 pages)
Table of Contents
Advertisement
Configuring the Switch with the CLI-Based
Setup Program
This appendix provides a CLI-based setup procedure for a Catalyst 3850 standalone switch or a switch
stack. To set up the switch by using Express Setup, see the Catalyst 3850 Switch Getting Started Guide.
Before connecting the switch to a power source, review the safety warnings in
Installation."
•
•
Accessing the CLI
Accessing the CLI Through Express Setup
You can access the CLI on an unconfigured switch by placing the switch in Express Setup mode and
then connecting a switch Ethernet port or the Ethernet management port to the Ethernet port of your PC
or workstation. To put the switch into Express Setup mode, follow the steps described in the getting
started guide for powering on the switch and using Express Setup.
When the switch is in Express Setup mode, open a Telnet session to the switch by entering the IP address
10.0.0.1. Enter the setup user EXEC command. Enter the information described in the
Initial Configuration Information" section on page
After you have entered the configuration information for the switch, save it to flash memory by using
the write memory privileged EXEC command.
While in Express Setup mode, the IP address 10.0.0.1 remains active on the switch until you enter the
Note
write memory command. You lose the Telnet connection after entering the write memory command.
For more information about using the CLI, see the command reference for this release.
OL-26779-02
Accessing the CLI, page C-1
Entering the Initial Configuration Information, page C-5
A P P E N D I X
C-5.
Catalyst 3850 Switch Hardware Installation Guide
C
Chapter 2, "Switch
"Entering the
C-1
Hide quick links:
Advertisement
Table of Contents
