Table of Contents
Advertisement
Preparing for Server Component Installation
Disconnect the power cords from the power supplies in your server to completely power off the server.
Step 3
Removing and Replacing the Server Top Cover
To remove or replace the top cover of the server, follow these steps:
You do not have to remove the cover to replace hard drives or power supplies.
Tip
Remove the top cover:
Step 1
a.
b.
c.
Replace the top cover:
Step 2
a.
b.
Figure 3-4
1
1
Cisco UCS C260 Server Installation and Service Guide
3-8
Simultaneously press the two release buttons. See
Push the top cover toward the server rear about one-half inch (1.27 cm), until it stops.
Lift the top cover straight up from the server and set it aside.
Place the cover on top of the server about one-half inch (1.27 cm) behind the lip of the chassis front
cover panel. The cover should sit flat when the edge flanges are sitting in the grooves in the chassis.
Slide the top cover toward the front cover panel until it stops and the release buttons lock.
Removing the Top Cover
2
Release buttons
Chapter 3
Figure
3-4.
2
Front cover panel
Maintaining the Server
OL-24342-01
Advertisement
Table of Contents
