Operating instructions Incognito G 643 SCVi G 843 Vi G 843 SCVi To prevent accidents and machine damage, read these instructions installation or use. M.-Nr. 05 431 291...
Page 3
Adding detergent..........30 Running the dishwasher .
Page 4
Keep these operating instructions in Installation and repair work should a safe place and pass them on to be performed by a Miele any future user. authorized service technician. Work by unqualified persons could be dangerous and could void the warranty.
Page 5
Do not tamper an installation in these applications. with the controls. Please contact the nearest Miele dealer To reduce the risk of injury, do not or the Miele Technical Service allow children to play in, on, or Department with specific requirements.
When loading tableware, place sharp items away from the door If the appliance is removed from its seal to prevent damage to the seal. installation and will not be used, Load knives pointing downwards to the door to the wash cabinet should be prevent injuries.
Page 7
Avant l’installation, assurez-vous que la tension et la fréquence indiquées sur la plaque signalétique correspondent bien à celles de l’alimentation électrique de la résidence afin de prévenir les blessures et d’éviter d’endommager l’appareil. Dans le doute, consultez un électricien qualifié. Avant de procéder à...
Page 8
électriques qui pourraient certaines circonstances. Veuillez causer des blessures ou des communiquer vos exigences dommages matériels. particulières au détaillant Miele le plus près de chez vous ou au Service technique.
Page 9
Au moment de charger la vaisselle, ne disposez pas les articles N’utilisez le lave-vaisselle que coupants à proximité du joint lorsque tous les panneaux sont d’étanchéité de la porte afin d’éviter de bien en place. l’endommager. Placez les couteaux Ne jouez pas avec les avec la pointe vers le bas afin d’éviter commandes.
Page 10
This dishwasher is exceptionally economical in the use of water and electricity. For best results follow these tips: ^ For lowest energy consumption and the gentlest washing of china and crystal, connect the dishwasher to a cold water source. ^ For fastest possible wash times, yet higher energy consumption, connect the dishwasher to a hot water source.
Upper spray arm (not visible) Detergent dispenser Cutlery tray Data plate Upper basket Control panel Water feed for middle spray arm Optic indicator Middle spray arm Salt reservoir Lower spray arm Triple Filter System Rinse aid reservoir Four height adjustable feet...
Page 12
On button / Indicator Off button Check / Refill indicators Program list Program selection buttons / indicators Remove the protective film from the program list before the first use. Every dishwasher is tested before leaving the factory. Any water remaining in the machine is from these tests and does not indicate that the machine has been used.
Page 13
^ Push the baskets in. ^ Lift the door and push until it clicks into position. ^ Pull the handle. If the door is opened during operation, the dishwasher will stop running. Once the door is closed the program will restart.
If your water hardness is consistently To achieve good cleaning results, the dishwasher needs soft water. Hard However, the dishwasher must still be water results in calcium deposits on programmed to correspond with the dishware and in the dishwasher. local water hardness. If your tap water hardness is above 8 gr/gal (values are in US gallons) Where the water hardness fluctuates...
Page 15
Your water hardness level must be An indicator corresponding to a preset programmed into the dishwasher using water hardness will light (see Table 1). the buttons on the control panel. The programming can be canceled and restarted at any time by turning the dishwasher off using the "Off"...
Page 16
^ Press the f button. ^ Open the door. The f indicator will light. ^ Turn off the dishwasher. An indicator corresponding to a set ^ Press and hold the a and c buttons. water hardness will light (see Table 2). At the same time turn on the dishwasher with the "On"...
Page 17
The salt reservoir must be filled with 2 quarts (2 l) of water The proper salt can be purchased from . Water does your Miele dealer or Miele. not have to be added with subsequent refills. ^ Carefully fill with salt. The salt reservoir holds approximately 4.5 lbs...
Page 18
When the salt reservoir is empty, the If your water is soft (below 8 gr/gal) the "Salt-PC" indicator will light, indicating salt reservoir should not be filled with that it should be refilled with salt. The indicator will remain lit and reactivation salt.
Rinse aid is recommended to prevent spotting on dishes and glassware. Filling the rinse aid reservoir with detergent will damage the reservoir. Only pour rinse aid formulated into the reservoir. ^ Pour liquid rinse aid into the reservoir until it is visible on the surface of the screen.
The dosage selector is preset to 3. This The rinse aid indicator on the control dispenses approximately 3 ml of rinse panel will light when the rinse aid aid per program. It can be adjusted reservoir needs refilling. from 1 to 6. When the indicator first comes on, there ^ Use a higher setting if spots appear will be enough rinse aid left for 2 - 3...
Page 21
^ The spray arms must not be blocked Do not wash items soiled with by items that are too tall or hang ash, sand, wax, grease or paint in through the baskets. Check the dishwasher. clearance by manually rotating the Ash and sand do not dissolve and spray arms.
Page 22
– There are no standard guidelines for washing glassware but, when in – Cutlery with wooden handles. doubt wash by hand. – Wooden cutting boards. – Wash delicate glassware with a low – Glued items such as old knives with temperature program and without the handles glued together around the extended drying feature to reduce...
^ For the best cleaning results, spoons and forks should be placed in the basket with handles down. Knives and other pointed objects can be loaded with their handles up to prevent injuries. ^ Place small spoons into the slots on either side of the cutlery basket.
Page 24
Spoon heads should be placed in contact with at least one of the serrated The removable cutlery tray makes retainers of the cutlery tray to ensure unloading flatware easy. Simply carry that water runs off freely. the cutlery tray to where the flatware is stored and put the entire basket away in one trip.
On select models, the upper basket can be raised or lowered to accommodate tall items. ^ Slide out the upper basket. Load the upper basket with small, lightweight, or delicate items such as cups, saucers, glasses, dessert bowls and flat pans. Long items such as soup ladles, mixing spoons and knives can be set across the front of the upper basket.
Raise the rack to make room for tall To allow water to run off the bottom of glasses. Lower it to double stack coffee mugs, place them slanted on top of the coffee bar. The bar can also be smaller pieces. used to separate two rows of glasses.
Page 27
For larger and heavier items such as plates, serving platters, sauce pans, bowls.
(select models) The bottle holder e.g. for milk or baby The guide at the front of the upper basket determines the maximum height bottles, can be inserted into the bottom for items placed in the lower basket so basket in more than one place. Position in any area marked white in the that the middle spray arm is not blocked.
Page 29
Additional inserts for the upper and lower baskets may be purchased from your Miele dealer or the Miele Technical Service Department. Vase / Bottle holder To wash milk or baby bottles attaches to the lower basket Mini Cutlery Basket To wash additional cutlery...
Page 30
Dishwasher detergents contain irritant and corrosive ingredients. Keep children away from detergent. Do not fill the detergent dispenser until you are ready to start the dishwasher. Only use detergents or formulated for residential dishwashers. The use of gel or liquid detergent is not recommended.
Page 31
^ Open the door. All Miele dishwashers are specially designed to shut off the water intake ^ Make sure the spray arms are not and drain the wash cabinet in the rare blocked. event of an internal water valve failure.
Page 32
A program is interrupted as soon as the If the door has not been closed yet: door is opened. ^ Press the program button of the new If the door is closed, the program will program. continue from where it was interrupted. ^ Close the door.
Page 33
Program When to use Program cycle Pre- Main Interim Final Dry- wash wash rinse rinse Pots & Pans For heavily soiled pots and pans with dried on food Main wash temperature Run-time Sani Wash Eextended wash time Main wash temperature Run-time Normal Plus Higher wash temperature helps to clean Main wash temperature...
Page 34
Water intake error. – Turn off the dishwasher. The "Intake/Drain" – Open the water valve. indicator flashes/lights. – Clean the water inlet filter, see maintenance instructions. The waterproof system has activated. – Call the Miele Technical Service Department.
Page 35
Water intake error. The water pressure is less The "Intake/Drain" than 4.5 psi (0.3 bar). indicator flashes. Contact a plumber. Drain error, water remains – Turn off the dishwasher. in the wash cabinet. – Clean the triple filter. The "Intake/Drain" See maintenance indicator flashes.
Page 36
– Turn the dishwasher off. fault. Despite the problem the dishwasher can be used. If the indicators flash again after the next program cycle, call Miele Technical Service. The spray arm is hitting Interrupt the program, an item in the basket. rearrange items blocking the spray arms.
The dishes were not See "Loading the loaded correctly. dishwasher". The program was not Select a more intensive powerful enough. program, see the "Program guide". Not enough detergent Use more detergent, see was used. "Adding detergent". The spray arm jets are Clean the spray arm jets, clogged.
Page 38
The wash temperature of Select a program with a the selected program was higher temperature. too low. Not enough detergent Use more detergent. was used. Not enough rinse aid was Increase the dosage, used. see "Before using for the first time". The salt reservoir is Add reactivation salt, empty.
Page 39
Natural dyes e.g. from Use more detergent, see vegetables may be the "Adding detergent". cause. Not enough Discoloration is detergent was used to permanent. break down natural dyes. The salt reservoir cap was Reseat and screw the cap not screwed on properly. on firmly.
Page 40
The Program Correction (PC) allows a Miele products will not be recognized technician to update the dishwasher to by Miele. Our goal is to prevent make use of new technology. unauthorized (and untrained) service personnel from working on your Miele...
Page 41
To transport the dishwasher, e.g. when moving to a new home, note the following: – Empty the dishwasher. – Secure any loose parts, e.g. hoses, cables, cutlery baskets. – Transport the dishwasher in the upright position. If unavoidable it may be transported on its back. Do not transport it on its side or on the door.
User Maintenance Instructions To prevent accidents and machine damage, read these instructions installation or use.
Page 44
The triple filter system in the base of the wash cabinet prevents food from being redeposited on dishes. It also protects the circulation pump from damage caused by foreign objects (e.g. broken glass, bones). The filter system should be cleaned every 4 - 6 months or whenever a foreign object is trapped.
Page 45
^ Return the filter so it lies flat in the To clean the underside of the filter, the flap must be opened: base of the wash cabinet. ^ Pull back the yellow clip. ^ Lock the filter by turning the handle clockwise.
Page 46
^ Remove the lower basket. Sometimes particles of food get stuck in the spray arm jets. The spray arms should be inspected and cleaned every 4 - 6 months. ^ Turn off the dishwasher before cleaning. Remove the spray arms as follows: ^ Remove the cutlery tray (if present).
Page 47
Dis To clean the optic indicator reflector: Cleaner available from your Miele ^ Open the door and remove the dealer or the Miele Technical Service reflector from the plastic mounting. Department. ^ Clean the reflector and the plastic mounting with a damp cloth.
Page 48
clean the control panel with a Never use abrasive cleaners, damp cloth. scouring pads, steel wool or caustic (oven) cleaners on the dishwasher. Do not use too much water when They damage the surface. cleaning the controls. Water could penetrate into the electronics and cause damage.
Page 49
^ Unscrew the intake hose. intake hose connection is ^ Carefully remove the rubber seal. recommended. These filters can be purchased from Miele. ^ Remove the filter using needle nose pliers and rinse under running water. ^ Return the filter and seal. Make sure they are seated correctly.
If the dishwasher is not completely drained at the end of a program, the drain pump or non-return valve may be blocked. ^ Turn off the dishwasher. ^ Remove the triple filter (see "Cleaning the filter in the wash cabinet"). ^ Use a jug or bowl to scoop water out of the wash cabinet.
Page 52
Alterations rights reserved / G 643 / G 843 Plus 2505 M.-Nr. 05 431 291 / 01...