How Do I Configure The Wireless Home Gateway - Cisco DPC2434 User Manual
Voip wireless home gateway
Hide thumbs
Also See for DPC2434:
- Datasheet (10 pages) ,
- Installation and operation manual (114 pages)
Table of Contents
Advertisement
How Do I Configure the Wireless Home Gateway?
How Do I Configure the Wireless Home Gateway?
To configure your wireless home gateway, you must first access the WebWizard
configuration pages. This section provides detailed instructions and procedures for
accessing the WebWizard pages and for configuring your wireless home gateway to
operate correctly. This section also presents examples and descriptions of each
WebWizard configuration page. Use the WebWizard pages to customize your
wireless home gateway to your needs rather than using the default settings. The
WebWizard pages in this section are organized in the order shown on the Setup
page.
Important: The WebWizard pages and the examples shown in this section are for
illustration purposes only. Your pages may differ from the pages shown in this
guide.
Note: If you are not familiar with the network configuration procedures detailed in
this section, contact your service provider before you attempt to change any of the
wireless home gateway default settings.
Accessing the Wireless Home Gateway
You must access the WebWizard in order to configure the wireless home gateway.
To gain access to the WebWizard, use the Web browser on the PC attached to the
gateway and complete the following steps.
1
Open the Web browser on your PC.
2
Type the following IP address and then select Go:
http://192.168.0.1.
3
The Web browser accesses the WebWizard and displays the default About Your
Modem page. This page displays information about your cable modem along
with a series of tabs for accessing other WebWizard configuration and operation
features.
56
4011350 Rev D
Advertisement
Table of Contents
