Cisco EPC2434 User Manual page 45
Voip wireless home gateway
Hide thumbs
Also See for EPC2434:
- User manual (146 pages) ,
- Installation and operation manual (114 pages)
Table of Contents
Advertisement
3
Connect the active RF coaxial cable to the CABLE connector on the back of the
wireless home gateway. The wireless home gateway begins an automatic search
to locate and sign on to the network that provides the telephone service. This
process may take up to 5 minutes. The modem will be ready for use when the
ONLINE LED status indicator on the front panel stops blinking and illuminates
continuously
Note: Use an optional cable signal splitter to add a TV, a DHCT or set-top
converter, or a VCR.
4
Test your telephone service by lifting the receiver of each attached telephone to
verify that the dial tone can be heard and that you can make and receive
telephone calls. This process may take several minutes.
Notes:
The TEL 1 and TEL 2 LED status indicators on the front panel of the wireless
home gateway illuminate when telephony service is enabled.
The TEL 1 or the TEL 2 LED status indicators on the front panel of the
wireless home gateway blink when the attached device is "off the hook."
4015258 Rev B
How Do I Install the Modem for Telephone Service?
45
Advertisement
Table of Contents
