Cisco EPC2434 User Manual page 49
Voip wireless home gateway
Hide thumbs
Also See for EPC2434:
- User manual (146 pages) ,
- Installation and operation manual (114 pages)
Table of Contents
Advertisement
Mounting the Wireless Home Gateway on a Wall
To mount the wireless home gateway on a wall
Complete these steps to mount the wireless home gateway on the wall.
1
Using a drill with a 3/16-in. bit, drill two holes in the wall as follows:
To mount the wireless home gateway vertically, drill the holes at the same
height and 4 inches apart.
To mount the wireless home gateway horizontally, drill the holes at the same
height and 4 inches apart.
Note: The graphic on the preceding page illustrates the location of the mounting
holes on the back of the wireless home gateway.
2
Are you mounting the wireless home gateway into a drywall or concrete surface
where a wooden stud is available?
If no, drive the anchor bolts into the wall, and install the mounting screws
into the anchor bolts leaving a gap of about 1/4-in. between the screw head
and the wall. Then, go to step 4.
If yes, go to step 3.
3
Install the mounting screws into the wall leaving a gap of about 1/4-in. between
the screw head and the wall. Then, go to step 4.
4
Verify that no cables or wires are connected to the wireless home gateway.
5
Lift the wireless home gateway into position. Slip the large end of both mounting
slots (located in the back of the wireless home gateway) over the mounting
screws, then slide the wireless home gateway down until the narrow end of the
keyhole slot contacts the screw shaft.
Important! Verify that the mounting screws securely support the wireless home
gateway before you release the unit.
4015258 Rev B
How Do I Mount the Modem on a Wall? (Optional)
49
Advertisement
Table of Contents
