Cisco 3200 Series Hardware Reference Manual page 119
Hide thumbs
Also See for 3200 Series:
- Use and care manual (282 pages) ,
- Upgrade manual (60 pages) ,
- Hardware upgrade manual (60 pages)
Table of Contents
Advertisement
SFP Module Replacement
This chapter describes how to replace small-form-factor pluggable (SFP) modules. SFP modules are
inserted into the SFP module slot on the Cisco 3270 Rugged Router card. These modules provide the
uplink optical interfaces, laser send (TX) and laser receive (RX).
The following are qualified Gigabit SFP modules:
Gigabit Multi-Mode SFP (Cisco part number: GLC-SX-MM-RGD):
•
Gigabit Single-Mode SFP (Cisco part number: GLC-LX-SM-RGD):
•
Each SFP must be of the same type as the SFP on the other end of the cable, and the cable must not
exceed the stipulated cable length for reliable communications.
has a bale-clasp latch.
We strongly recommend that you not install or remove the SFP module while the fiber-optic cable is
Caution
attached to it because of the potential damage to the cables, to the cable connector, or to the optical
interfaces in the SFP module. Disconnect the cable before you remove or install an SFP module.
Removing and installing an SFP module can shorten its useful life. Do not remove and insert SFP
modules more often than is necessary.
Figure B-1
To avoid damaging the cables, follow standard fiber optic cleaning procedures when connecting fiber
Caution
optic cables to fiber-optic ports.
OL-5816-10
SFP Module with a Bale-Clasp Latch
A P P E N D I X
Figure B-1
shows an SFP module that
Cisco 3200 Series Router Hardware Reference
B
B-1
- Quick Links:
- Introduction to the Cisco 3200 Series...
Hide quick links:
Advertisement
Table of Contents
