Advertisement
Available languages
Available languages
Linksys X1000
5. Connect the other end of the phone cable to the wall jack with ADSL
service or microfilter .
NOTE
If you experience static on your phone line, you may need a
microfilter or splitter . (This is required for users in the UK; other
users should contact their ISPs to verify . ISDN users do not need
a microfilter .) If you require a microfilter, you must install one for
each phone or fax that you use . To install a microfilter, plug it into
a phone jack that has ADSL service, then connect one end of the
provided phone cable to the microfilter's DSL port .
6. Connect one end of the power adapter cord to the Power port and the
other end to the electrical outlet .
7. Power on the computer that you will use to configure the modem-router .
8. The LEDs for Power, Wireless, and Ethernet (one for each connected
computer) should light up . If not, make sure the modem-router is
powered on and the cables are securely connected .
Set up your modem-router as only a router
NOTE
Run the Setup CD-ROM to install the modem-router . If you cannot
run the Setup CD-ROM, refer to the steps below .
To set up your modem-router as a router:
1. Connect one end of the provided Ethernet cable to your computer's
Ethernet adapter and the other end to an Ethernet port on the back of
the modem-router .
2. Connect one end of an Ethernet cable to the Cable port on the back of
the modem-router, then connect the other end to an available Ethernet/
LAN port on your modem .
3. Connect one end of the power adapter cord to the Power port and the
other end to the electrical outlet .
4. Power on the computer that you will use to configure the modem-router .
5. The LEDs for Power, Wireless, and Ethernet (one for each connected
computer) should light up . If not, make sure the modem-router is
powered on and the cables are securely connected .
Installation
5
Advertisement
Chapters
