Ip Igmp Snooping Vlan Static - Cisco Catalyst 3550 Command Reference Manual

Multilayer switch

Hide thumbs Also See for Catalyst 3550:

Table of Contents

ip igmp snooping vlan static

Use the ip igmp snooping static global configuration command to enable Internet Group Management

Protocol (IGMP) snooping and to statically add a Layer 2 port as a member of a multicast group. Use

the no form of this command to remove ports specified as members of a static multicast group.

Syntax Description

interface interface-id

By default, there are no ports statically configured as members of a multicast group.

Command Modes

Global configuration

Command History

Usage Guidelines

VLAN IDs 1002 to 1005 are reserved for Token Ring and FDDI VLANs and cannot be used in IGMP

The configuration is saved in NVRAM.

This example shows how to statically configure a host on an interface:

Switch(config)# ip igmp snooping vlan 1 static 0100.5e02.0203 interface gigabitethernet0/1

Configuring port gigabitethernet0/1 on group 0100.5e02.0203

You can verify your settings by entering the show ip igmp snooping privileged EXEC command.

Catalyst 3550 Multilayer Switch Command Reference

ip igmp snooping vlan vlan-id static ip-address interface interface-id

no ip igmp snooping vlan vlan-id static ip-address interface interface-id

Enable IGMP snooping on the specified VLAN. The range is 1 to 1001 and

1006 to 4094.

Add a Layer 2 port as a member of a multicast group with the specified group

Specify the interface of the member port. The keywords have these

Modification

This command was introduced.

fastethernet interface number—a Fast Ethernet IEEE 802.3 interface.

gigabitethernet interface number—a Gigabit Ethernet IEEE 802.a

port-channel interface number—a channel interface. The range is 0 to

Catalyst 3550 Switch Cisco IOS Commands

Table of Contents