Connection Procedures And Precautions; Connecting To A Console Terminal Or Modem; Connecting To The Console Port With Microsoft Windows - Cisco 1900 series Hardware Installation
Hide thumbs
Also See for 1900 series:
- Quick start manual (8 pages) ,
- Brochure (411 pages) ,
- Manual (111 pages)
Table of Contents
Advertisement
Connecting to a Console Terminal or Modem
Connection Procedures and Precautions
Connect each WAN and LAN cable to the appropriate connector on the chassis or interface card.
•
•
•
•
For cable pinouts, refer to the online document
Connecting to a Console Terminal or Modem
Your router has asynchronous serial, USB, console and auxiliary ports. These ports provide
administrative access to your router either locally (with a console terminal or PC) or remotely (with a
modem).
The following cables and adapters may be used for connecting your router to a console terminal, PC, or
modem:
•
•
•
The first time a Windows based PC is connected to the router, a USB device driver must be installed.
Note
See
This section describes how to connect a console terminal or PC to the console port and how to connect
a modem to the auxiliary port.
Connecting to the Console Port with Microsoft Windows
To configure the router through the Cisco IOS command-line interface (CLI), you must connect the
router console port to a terminal or PC. See
page
A Microsoft Windows PC must have HyperTerminal or similar terminal emulation software installed.
The software should be configured with the following parameters: 9600 baud, 8 data bits, no parity, 1
stop bit, and no flow control. Refer to the Cisco 3900 Series, 2900 Series, and 1900 Series Software
Configuration Guide for detailed information about using Cisco IOS software for configuring the router.
To connect the router to a terminal or PC, follow these steps:
Connect the end of the console cable with the RJ-45 connector to the light blue console port on the
Step 1
router, or USB 5-pin mini Type-B to the USB console port as shown in
USB port for the first time on a Windows based PC, you must install the Windows USB driver. See
"Installing the Cisco Microsoft Windows USB Device Driver" section on page
Cisco 1900 Series Hardware Installation
4-16
Position the cables carefully, so that they do not put strain on the connectors.
Organize the cables in bundles so that cables do not intertwine.
Inspect the cables to make sure that the routing and bend radiuses are satisfactory. Reposition the
cables, if necessary.
Install cable ties in accordance with your site requirements.
USB Console cable—USB 5-pin mini Type-B to USB Type-A. See
on page 2-6
for port details and
Console cable— EIA RJ-45 to DB-9
Modem adapter—DB-9 to DB-25
Installing the Cisco Microsoft Windows USB Device Driver, page
2-5.
Cisco Modular Access Router Cable
"Specifications" section on page
"Console and Auxiliary Port Considerations" section on
Chapter 4
Installing and Connecting the Router
Specifications.
"USB Serial Console" section
1-14.
4-18.
Figure
4-12. If connecting the
4-18.
OL-19084-02
- Quick Links:
- Hardware Features
- Led Indicators
Hide quick links:
Advertisement
Table of Contents
