Removing And Replacing The Power Supply - Cisco Catalyst 4900M Installation Manual
Catalyst 4900m switch
Hide thumbs
Also See for Catalyst 4900M:
- Installation manual (128 pages) ,
- Troubleshooting manual (6 pages) ,
- Configuration handbook (359 pages)
Table of Contents
Advertisement
Removing and Replacing the Power Supply
Step 2
Step 3
Removing and Replacing the Power Supply
Warning
Note
Cisco Catalyst 4900M Switch Installation Guide
3-22
When the switch is online, enter the show module command. Verify that the
system acknowledges the new module and that the module's status is listed as
good in the command output.
If the module is not operational, reseat it. If the module is still not operational,
contact your customer service representative.
This section describes how to remove and install the AC and DC-input power
supplies. This information is presented in the following sections:
Required Tools, page 3-23
•
Removing a Power Supply, page 3-23
•
Installing a Power Supply, page 3-24
•
Hazardous voltage or energy is present on the backplane when the system is
operating. Use caution when servicing. Statement 1034
Locate your power supply and notice the location of the captive installation
screws.
The power supplies are hot-swappable, so in redundant mode you will not need to
power down the switch to replace most power supplies. In combined mode some
slots may lose power during power supply replacement.
Chapter 3
Installing the Switch
78-18350-01
Advertisement
Table of Contents
Troubleshooting
