Physical Description
Front Panel
Figure 2-1
describes the components of the front panel.
Figure 2-1
Table 2-1
Component
10/100 BaseT connector An RJ-45 connector that provides the primary Ethernet connection for the IP
SERIAL connector
RST button
GK Reg LED
CD LED
ACT LED
ALARM LED
10/100 BaseT LEDs
Cisco Unified Videoconferencing 3527 PRI Gateway Rear Panel
Figure 2-2
unit.
Figure 2-2
Installation and Upgrade Guide for Cisco Unified Videoconferencing 3522 BRI Gateway and 3527 PRI Gateway Release 5.6
2-2
shows the front panel of the Cisco Unified Videoconferencing 3500 Gateway unit.
Cisco Unified Videoconferencing 3500 Gateway Front Panel
10/100 Base T
Front Panel Components
Description
network port.
A DB-9 connector that allows you to connect a PC terminal for local
configuration.
Allows you to reset the Cisco Unified Videoconferencing 3500 Gateway unit
manually.
Lights green when the Cisco Unified Videoconferencing 3500 Gateway unit
is registered with a gatekeeper.
Lights green when a PRI or BRI line is enabled and a carrier signal is
detected
Lights green to indicate that there are active calls in the Cisco Unified
Videoconferencing 3500 Gateway unit.
Lights green to indicate that an error has occurred and the Cisco Unified
Videoconferencing 3500 Gateway unit requires resetting.
The top part of the 10/100 BaseT connector contains two LED indicators.
The left-hand LED lights green when the local IP network link is active. The
right-hand LED lights green if the connection speed is 100 Mbps, and is off
when the connection speed is 10 Mbps.
shows the rear panel components of the Cisco Unified Videoconferencing 3527 PRI Gateway
Table 2-2
describes these components.
Cisco Unified Videoconferencing 3527 PRI Gateway: Rear Panel
Chapter 2
Setting Up Your Cisco Unified Videoconferencing 3500 Gateway
GK Reg
CD
SERIAL
RST
ALARM
ACT
Table 2-1
PWR
ACT
ACT
D-Ch
D-Ch
ALARM
ALARM
PORT-2
PORT-1
OL-17010-01