Table of Contents
Advertisement
Connecting Cisco IPVC 3500 PRI Gateways to the Network
Procedure
Step 1
Connect a cable from the LAN to the 10/100BaseT port on the front panel of the gateway. The
10/100BaseT port accepts an RJ-45 connector.
Caution
Connect the first ISDN line to the BRI Port 1 in the rear panel of the gateway. The BRI port accepts an
Step 2
RJ-45 connector.
Connect the second ISDN line to the BRI Port 2 in the rear panel of the gateway. The BRI port accepts
Step 3
an RJ-45 connector.
Connect the third ISDN line to the BRI Port 3in the rear panel of the gateway. The BRI port accepts an
Step 4
RJ-45 connector.
Connect the fourth ISDN line to the BRI Port 4 in the rear panel of the gateway. The BRI port accepts
Step 5
an RJ-45 connector.
Connecting Cisco IPVC 3500 PRI Gateways to the Network
The Cisco IPVC 3500 PRI Gateways can connect to the LAN only through the front panel. The gateway
supports a 10/100BaseT, full-duplex Ethernet interface through an RJ-45 connector.
Procedure
Step 1
Plug an RJ-45 connector attached to an appropriate Ethernet cable into the 10/100BaseT port on the front
panel of the gateway.
Connecting PRI Lines to the Cisco IPVC 3500 PRI Gateways
The Cisco IPVC 3526 PRI Gateway has one PRI port and the ICisco IPVC 3540 PRI Gateway has two
PRI ports. You must connect a PRI line to at least one port. The gateway supports T1 and E1 PRI
configurations.
Connecting the Cisco IPVC 3500 Series Gateway to a Power
Source
This section describes how to supply power to the Cisco IPVC 3500 Series Gateway. The gateway is
equipped with an autoswitching power supply that supports 100-240 VAC at 50/60 Hz.
Administrator's Guide for Cisco IPVC 3521 BRI Gateway, Cisco IPVC 3526 PRI Gateway, and Cisco IPVC 3540 PRI Gateway
2-12
The Cisco IPVC 3521 BRI Gateway does not support the Ethernet port on the rear panel. Do
not use.
Chapter 2
Installing the Cisco IPVC 3500 Series Gateway
OL-7995-01
- Quick Links:
- Table of Contents
- Objectives
Hide quick links:
Advertisement
Table of Contents
