Table of Contents
Advertisement
Configuring Gateway Settings
•
•
This setting is selected by default. If unselected, the gateway passes in-band DTMF signals to the IP-side
endpoint unchanged. If you do select this setting, perform step 6.
In the Apply to field, choose the type of calls to which ISDN-to-IP DTMF processing applies: Voice
Step 6
calls or Voice and video calls. Voice calls is the default setting.
Note
Configuring Advanced Commands
You can send text-based commands to a Cisco IPVC 3500 Series Gateway for enhanced control. You can
use these advanced commands to change certain settings in real time and monitor information such as
debug information. Advanced commands are not case sensitive.
Table 3-10
.
Table 3-10
Command
AddService2SrcNum
CallSignalPort
DownSpeed
Administrator's Guide for Cisco IPVC 3521 BRI Gateway, Cisco IPVC 3526 PRI Gateway, and Cisco IPVC 3540 PRI Gateway
3-32
Converts in-band DTMF signals from the ISDN-side endpoint to out-of-band H.245 signals if the
IP-side endpoint is located on an H.323 network.
Passes incoming in-band DTMF signals to the IP-side endpoint unchanged.
Enabling DTMF detection for video calls reduces the number of supported calls at 128 Kbps
from 30 to 22.
describes common advanced commands.
Advanced Command Settings
Chapter 3
Description
Notifies the IP endpoint of the gateway service number
to which the ISDN-side endpoint has called.
Parameters: Enable/Disable.
Notifies the gatekeeper to which the gateway is
registered on which port to communicate.
Parameters: 1000 to 3000.
Remarks: The number must be unique and not used for
any other purpose.
Instructs the gateway to support downspeeding.
Parameters: Enable/Disable.
Configuring the Cisco IPVC 3500 Series Gateway
OL-7995-01
- Quick Links:
- Table of Contents
- Objectives
Hide quick links:
Advertisement
Table of Contents
