Cisco UCS C210 Installation And Service Manual page 72
Generations m1 and m2
Hide thumbs
Also See for UCS C210:
- Installation and service manual (114 pages) ,
- Configuration manual (88 pages) ,
- Setup (10 pages)
Table of Contents
Advertisement
Align the PCIe card connector with the riser card socket and push on both ends of the card evenly
b.
to fully engage the card connector with the riser card socket (see
c.
Install the screw that secures the rear plate of the card to the assembly rear opening.
Replace any cables that were connected on the old card to connectors on the new card.
d.
Set the assembly in place, aligning the riser cards with the PCIe slots on the motherboard.
e.
Press down evenly on both ends of the assembly to fully engage the riser cards with the PCIe slots
f.
on the motherboard.
Note
Replace the screw that secures the assembly to the chassis.
g.
h.
Replace the top cover.
i.
Replace the server in the rack, replace power cords and any other cables, and then power on the
server by pressing the Power button.
Figure 3-18
Figure 3-19
1
Riser card assembly removed from chassis (top view) 2
3
PCIe card
5
PCIe card securing screw (attaches to assembly)
Cisco UCS C210 Server Installation and Service Guide
3-34
Older servers have a screw that secures the PCIe riser to the rear of the chassis, but newer servers
do not have this screw. If your server has the screw, continue with the next step to replace it. If
your server does not have this screw, skip to Step
PCIe Slot Numbering and Physical Orientation, Facing Server Rear
PCIe Slot 4
PCIe Slot 5
Removing and Replacing a PCIe Card
1
2
3
h.
PCIe Slot 1
PCIe Slot 2
PCIe Slot 3
4
5
Riser card
4
PCIe card rear plate
Chapter
Figure
3-19).
OL-20887-02
Advertisement
Table of Contents
