Nic Modes And Nic Redundancy Settings - Cisco UCS C210 Installation And Service Manual
Generations m1 and m2
Hide thumbs
Also See for UCS C210:
- Installation and service manual (114 pages) ,
- Configuration manual (88 pages) ,
- Setup (10 pages)
Table of Contents
Advertisement
NIC Modes and NIC Redundancy Settings
This server has the following NIC mode settings that you can choose from:
•
•
•
Note
This server has the following NIC redundancy settings that you can choose from:
•
•
•
Cisco UCS C210 Server Installation and Service Guide
2-12
Dedicated—The two 10/100 management ports are used to access the CIMC. You have to select a
NIC redundancy and IP setting.
Shared LOM (default)—The two 1Gb Ethernet ports are used to access the CIMC. This is the factory
default setting, along with Active-active NIC redundancy and DHCP enabled.
Cisco Card—The ports on an installed Cisco network adapter card are used to access the CIMC. You
have to select a NIC redundancy and IP setting.
The Cisco Card NIC mode is currently supported only with a Cisco UCS P81E Virtual Interface
Card (N2XX-ACPCI01) that is installed in PCIe slot 1 (see
Special Considerations for the Cisco UCS P81E Virtual Interface Card (N2XX-ACPCI01),
page
3-35.
None—The Ethernet ports operate independently and do not fail over if there is a problem.
Active-standby—If an active Ethernet port fails, traffic fails over to a standby port.
Active-active—All Ethernet ports are utilized simultaneously.
Figure 3-18 on page
3-34). See also
OL-20887-02
Chapter
Advertisement
Table of Contents
