Replacing A Pcie Card (Mass Storage Controllers) - Cisco UCS C210 Installation And Service Manual
Generations m1 and m2
Hide thumbs
Also See for UCS C210:
- Installation and service manual (114 pages) ,
- Configuration manual (88 pages) ,
- Setup (10 pages)
Table of Contents
Advertisement
Replacing a PCIe Card (Mass Storage Controllers)
For network adapter PCIe cards, see the
Note
page
The qualified and supported part numbers for this component are subject to change over time. For the most
up-to-date list of replaceable components, see the following URL and then scroll to Technical Specifications:
http://www.cisco.com/en/US/products/ps10493/products_data_sheets_list.html
Note
If you do not know which cards are installed in your server, see the
Is in Your Server" section on page
Note
This server contains a default drive backplane called an extender, which supports controller connection
for up to 8 drives. To control more than 8 drives (maximum 16), the server must be ordered with the
optional expander backplane. The extender/expander backplanes are not field-upgradeable. See the
"Supported RAID Controllers and Required Cables" section on page
LSI MegaRAID SAS controller cards are enabled with beep codes that can indicate activity within the
Note
RAID array. See the
Installing a PCIe card requires that you first remove the riser card assembly from the chassis. The PCIe
slot numbering on the riser card assembly is shown in
Figure 3-20
Cisco UCS C210 Server Installation and Service Guide
3-36
3-33.
"LSI MegaRAID Card Beep Codes" section on page C-6
PCIe Slot Numbering and Physical Orientation, Facing Server Rear
PCIe Slot 4
PCIe Slot 5
"Replacing a PCIe Card (Network Adapters)" section on
C-4.
Figure 3-20
PCIe Slot 1
PCIe Slot 2
PCIe Slot 3
"How to Determine Which Controller
C-1.
for more information.
(as viewed from the rear of the server):
Chapter
OL-20887-02
Advertisement
Table of Contents
