hit counter script
  1. Manuals
  2. Brands
  3. Husqvarna Manuals
  4. Cutter
  5. Cut-n-Break K 760
  6. Operator's manual

Cutting Blades; General; Abrasive Blades - Husqvarna Cut-n-Break K 760 Operator's Manual

Husqvarna power cutter operator's manual
Hide thumbs Also See for Cut-n-Break K 760:
Table of Contents

Advertisement

General

WARNING! A cutting blade may burst and
!
cause injury to the operator.
•
Cutting blades are available in two basic designs;
abrasive baldes and diamond blades.
•
High-quality blades are often most economical. Lower
quality blades often have inferior cutting capacity and a
shorter service life, which results in a higher cost in
relation to the quantity of material that is cut.
•
Make sure that the right bushing is used for the cutting
blade to be fitted on the machine. See the instructions
under the heading Assembling the cutting blade.
Suitable cutting blades

Cutting blades

K760

Abrasive blades

Yes*
Diamond blades
Yes
Toothed blades
No
*Without water
Cutting blades for different materials
WARNING! Never use a cutting blade for any
!
other purpose than that it was intended for.
Cutting plastics with a diamond blade can
cause kickback when the material melts due
to the heat produced when cutting and
sticks to the blade. Never cut plastic
materials with a diamond blade!
Follow the instructions supplied with the cutting blade
concerning the suitability of the blade for various applications,
or consult your dealer in case of doubts.
Concrete Metal Plastic Cast iron
Abrasive blades X
Diamond blades X
* NB! Only specialty blades.
8 –
English
CUTTING BLADES
X
X
X
X*
X*
Hand-held, high-speed machines
WARNING! Never use a cutting blade at a
!
lower speed rating than that of the power
cutter. Only use cutting blades intended for
high speed handheld power cutters.
•
Our cutting blades are manufactured for high-speed,
portable power cutters.
•
Check that the blade is approved for the same or higher
speed according to the aproval plate of the engine. Never
use a cutting blade with a lower speed rating than that of
the power cutter.
Blade vibration
•
The blade can become out-of-round and vibrate if an
excessive feed pressure is used.
•
A lower feed pressure can stop the vibration. Otherwise
replace the blade.
Abrasive blades
•
The cutting material on abrasive blades consists of grit
bonded using an organic binder. "Reinforced blades" are
made up of a fabric or fibre base that prevents total
breakage at maximum working speed if the blade should
be cracked or damaged.
•
A cutting blade's performance is determined by the type
and size of abrasive corn, and the type and hardness of
the bonding agent.
•
Ensure the blade it not cracked or damaged in any other
way.
•
Test the abrasive blade by hanging it on your finger and
tapping it lightly with a screwdriver or the like. If the blade
does not produce a resonant, ringing sound it is damaged.

Advertisement

Table of Contents
loading

Related Manuals for Husqvarna Cut-n-Break K 760

Related Content for Husqvarna Cut-n-Break K 760

This manual is also suitable for:

K 760

Table of Contents