Starting And Stopping - Husqvarna K960 Operator's Manual
Husqvarna cut-off saw operator's manual
Hide thumbs
Also See for K960:
- Operator's manual (24 pages) ,
- Operator's manual (24 pages) ,
- Operator's manual (24 pages)
Table of Contents
Advertisement
Starting and stopping
WARNING! Note the following before
!
starting:
Do not start the power cutter without the belt
guard fitted. Otherwise the clutch could
come loose and cause personal injuries.
Always move the machine away from the
refuelling area before starting.
Ensure that you and the machine have a
good working stance and that the cutting
blade can rotate freely.
Keep people and animals well away from the
working area.
Starting a cold engine
Ignition: Slide the ignition switch to the left.
Choke: Pull the choke control fully out.
Start throttle lock: Press in the throttle trigger lock, throttle
control and then the start throttle lock (A). Release the throttle
control and it is locked in the half throttle position. The lock
releases when the throttle control is pressed in fully.
Decompression valve: Press in the valve to reduce the
pressure in the cylinder, this is to assist starting the power
cutter. The decompression valve should always be used when
starting. The valve automatically returns to its initial position
when the machine starts.
STARTING AND STOPPING
Starting a warm engine
Use the same starting procedure as for a cold engine but
without setting the choke control in the choke position.
Starting
WARNING! The cutting blade rotates when
!
the engine is started. Make sure it can rotate
freely.
Grip the front handle with your left hand. Put your right foot on the
lower section of the rear handle pressing the machine against
the ground. Never twist the starter cord around your hand.
Grip the starter handle, slowly pull out the cord with your right
hand until you feel some resistance (the starter pawls grip),
now quickly and powerfully pull the cord.
CAUTION! Do not pull the starter cord all the way out and do
not let go of the starter handle when the cord is fully extended.
This can damage the machine.
When the engine starts, quickly apply full throttle to
automatically disengage fast idle.
Stopping
The engine is stopped by switching the ignition off using the
stop switch.
– 15
English
Hide quick links:
Advertisement
Table of Contents
