Cisco Catalyst 2950 Command Reference Manual page 276
Desktop switch
Hide thumbs
Also See for Catalyst 2950:
- Configuration manual (710 pages) ,
- Command reference manual (686 pages) ,
- Software configuration manual (674 pages)
Table of Contents
Advertisement
spanning-tree guard
Do not enable root guard on interfaces that will be used by the UplinkFast feature. With UplinkFast, the
backup interfaces (in the blocked state) replace the root port in the case of a failure. However, if root
guard is also enabled, all the backup interfaces used by the UplinkFast feature are placed in the
root-inconsistent state (blocked) and prevented from reaching the forwarding state. The UplinkFast
feature is not available when the switch is operating in MST mode.
Loop guard is most effective when it is configured on the entire switched network. When the switch is
operating in PVST mode, loop guard prevents alternate and root ports from becoming designated ports,
and spanning tree does not send bridge protocol data units (BPDUs) on root or alternate ports. When the
switch is operating in MST mode, BPDUs are not sent on nonboundary ports only if the port is blocked
by loop guard in all MST instances. On a boundary port, loop guard blocks the port in all MST instances.
To disable root guard or loop guard, use the spanning-tree guard none interface configuration
command. You cannot enable both root guard and loop guard at the same time.
You can override the setting of the spanning-tree loopguard default global configuration command by
using the spanning-tree guard loop interface configuration command.
Examples
This example shows how to enable root guard on all the VLANs associated with the specified interface:
Switch(config)# interface fastethernet0/3
Switch(config-if)# spanning-tree guard root
This example shows how to enable loop guard on all the VLANs associated with the specified interface:
Switch(config)# interface fastethernet0/3
Switch(config-if)# spanning-tree guard loop
You can verify your settings by entering the show running-config privileged EXEC command.
Related Commands
Command
show running-config
spanning-tree cost
spanning-tree loopguard default
spanning-tree mst cost
spanning-tree mst port-priority
spanning-tree mst root
spanning-tree port-priority
spanning-tree vlan
Catalyst 2950 Desktop Switch Command Reference
2-252
Description
Displays the current operating configuration. For syntax
information, select Cisco IOS Configuration Fundamentals
Command Reference for Release 12.1 > Cisco IOS File
Management Commands > Configuration File Commands.
Sets the path cost for spanning-tree calculations.
Prevents alternate or root ports from becoming designated
ports because of a failure that leads to a unidirectional link.
Configures the path cost for MST calculations.
Configures an interface priority.
Configures the MST root switch priority and timers based on
the network diameter.
Configures an interface priority.
priority
Sets the switch priority for the specified spanning-tree
instance.
Chapter 2 Cisco IOS Commands
78-11381-05
Hide quick links:
Advertisement
Table of Contents
