Cutting Blades; General - Husqvarna K 3000 Operator's Manual
K 3000 vac
Hide thumbs
Also See for K 3000:
- Operator's manual (22 pages) ,
- Operator's manual (24 pages) ,
- Operator's manual (20 pages)
Table of Contents
Advertisement
General
WARNING! A cutting blade may burst
!
and cause injury to the operator.
•
Cutting blades are available in two basic designs;
abrasive baldes and diamond blades.
•
High-quality blades are often most economical. Lower
quality blades often have inferior cutting capacity and
a shorter service life, which results in a higher cost in
relation to the quantity of material that is cut.
•
Make sure that the right bushing is used for the cutting
blade to be fitted on the machine. See the instructions
under the heading Assembling the cutting blade.
Suitable cutting blades
K 3000 without
Cutting blades
a Vac
attachment
Abrasive blades Yes
Diamond blades Yes
Toothed blades
No
Cutting blades for different materials
WARNING! Never use a cutting blade for
!
any other purpose than that it was
intended for.
Cutting plastics with a diamond blade
can cause kickback when the material
melts due to the heat produced when
cutting and sticks to the blade. Never cut
plastic materials with a diamond blade!
Cutting in metal generates sparks that
may cause fire. Do not use the machine
near to ignitable substances or gases.
Cutting metal is not allowed with the Vac
attachment.
Follow the instructions supplied with the cutting blade
concerning the suitability of the blade for various
applications, or consult your dealer in case of doubts.
CUTTING BLADES
* Only without the Vac attachment.
* * Only specialty blades. Only without the Vac
attachment.
Hand-held, high-speed machines
•
•
K 3000 with a
Vac attachment
No
Yes
No
Blade vibration
•
•
Concrete Metal
Abrasive
X
blades*
Diamond
X
blades
WARNING! Never use a cutting blade at a
!
lower speed rating than that of the power
cutter. Only use cutting blades intended
for high speed handheld power cutters.
Our cutting blades are manufactured for high-speed,
portable power cutters.
Check that the blade is approved for the same or
higher speed according to the aproval plate of the
engine. Never use a cutting blade with a lower speed
rating than that of the power cutter.
The blade can become out-of-round and vibrate if an
excessive feed pressure is used.
A lower feed pressure can stop the vibration.
Otherwise replace the blade.
Plastic Cast iron
X*
X
X
X**
----
X**
English
–
7
Advertisement
Table of Contents
