Transport And Storage - Husqvarna K 3000 Operator's Manual
K 3000 vac
Hide thumbs
Also See for K 3000:
- Operator's manual (22 pages) ,
- Operator's manual (20 pages) ,
- Operator's manual (24 pages)
Table of Contents
Advertisement
Diamond blades for dry cutting
•
Diamond blades for dry cutting can be used both with
and without water cooling.
•
When dry cutting, lift the blade out from the cut every
30–60 seconds and let it rotate in the air for 10
seconds to let it cool. If this is not done, the blade may
be overheated.
Diamond blades for wet cutting
NOTICE! Wet cutting should not be performed with the
Vac attachment. Wet concrete sludge considerably
reduces the suction capacity of the Vac attachment.
•
Diamond blades for wet cutting must be water cooled.
If this is not done, the blade may be overheated.
•
Water cooling cools the blade and increases its
service life while also reducing the formation of dust.
Transport and storage
•
Do not store or transport the power cutter with the
cutting blade fitted. All blades should be removed from
the cutter after use and stored carefully.
•
Store cutting blades in dry, frost free conditions.
Special care should be taken with abrasive blades.
Abrasive blades must be stored on a flat, level
surface. If an abrasive blades is stored in humid
conditions, this can cause imbalance and result in
injury.
•
Inspect new blades for transport or storage damage.
CUTTING BLADES
–
English
9
Advertisement
Table of Contents
