Table of Contents
Advertisement
Installing the Switch Chassis
Installing Air Filters
You can attach the optional air filters to the inside of the front door, the sides of the front door, and the cable
management side frames.
Before You Begin
• Verify that the cable management frames are installed on the chassis.
• Verify that the optional front door is installed or available for installation.
• Verify that you have the following tools or equipment:
Step 1
Attach the divider bracket to the left and right cable management side assemblies as follows:
a) Position the divider bracket between the right and left cable management assemblies between the bottom I/O module
and the power supplies. The back edge of the divider bracket has two curved corners that should come in contact
with the chassis.
b) Align the two slots on both sides of the bracket with the pins that stick out from the upper portion of the lower cable
management frame (power-supply cable management frame) and lower the bracket past the pins until the bracket
stops.
c) Push the bracket about 0.5 inches (1 cm) to the front of the chassis until it stops.
A screw hole on each side of the divider bracket aligns with a screw hole in each cable management side assembly.
d) Secure the divider bracket to both cable management side assemblies using two M3 x 8 mm screws (one screw for
each of two sides) and tightening the screws to 5 to 7 in-lb (0.56 to 0.79 N.m) of torque.
Step 2
Insert the door filter inside the back side of the door as follows:
a) Open the front door and pull it off of the chassis.
b) Place the front of the door on a table top so that the back (open) side is facing up.
c) Remove the largest air filter from its packaging, hold the side with the hexagonal shaped holes facing up, and insert
the filter into the open back side of the door.
If necessary, push in the spring clips on the side of the filter to push the filter into the door. The filter snaps into place
on the door.
Step 3
Attach the two narrow brush filters to the sides of the door as follows:
OL-31330-01
◦ Optional air filter kit is available for installation.
◦ Divider bracket
◦ M3 x 8 mm screws (2)
◦ Door filter
◦ Narrow brush filters (2)
◦ Cable management frame air filters (2)
◦ M4 x 12 mm screws (4)
◦ Manual Phillips torque screwdriver
Cisco Nexus 7706 Hardware Installation Guide
Installing Air Filters
39
Hide quick links:
Advertisement
Table of Contents
