Directional Pipe Formation - LG LS091HSV3 Installation Manual

Single zone high efficiency, standard, extended pipe, and mega wall mounted

Hide thumbs Also See for LS091HSV3:

Owner's manual (102 pages)

Installation manual (76 pages)

Engineering manual (76 pages)

Table of Contents

Pipe Bundling

See Figure 40 for proper pipe and cable bundling. Note the placement

of the piping along with the necessary insulation material.

1. Be sure to wrap each pipe with proper insulation material.

2. Secure the piping by wrapping vinyl tape around the pipe.

• Use the narrow size tape for wrapping the actual pipe.

3. You can include the drain hose within the bundled piping and wrap all

of them together using the wider vinyl tape as shown in Figure 41.

• The end of the drain hose outlet must be routed above the ground.

Indoor Unit Installed Above Outdoor Unit

1. Refer to Figure 42 while following the procedures below.

2. Tape the piping, drain hose and connecting cable from down to up.

3. Secure the taped piping along the exterior wall using pipe

clamps.

4. Create trap above the electrical connections cover, in order to pre-

vent water from penetrating electrical components and wiring.

Indoor Unit Installed Below Outdoor Unit

1. Refer to Figure 43 while following the procedures below.

2. Tape the piping, drain hose and connection cable from down to up.

3. Secure the taped piping along the exterior wall using pipe

clamps.

4. Create trap above the electrical connections cover, in order to

prevent water from entering the room.

Figure 42: IDU Above ODU - Piping and Trap

Indoor Unit Installed ABOVE

Outdoor Unit - Piping/Trap

Seal small openings

around pipings with a

gum type sealant.

Pipe Clamps

to Secure Pipe

Against Wall

Trap is required to prevent water

from entering into electrical parts.

refrigerant PiPing connectionS

Connecting cable

Pipings

Taping

Drain hose

Due to our policy of continuous product innovation, some specifications may change without notification.